Loading ...
Loading ...
Loading ...
21
• Only the «mc» chopper accessory (11) with the
special ice blade (11c) is allowed to crush ice
cubes.
• If using the appliance to puree hot food ensure
the liquid is not boiling. Allow hot food to cool
slightly to avoid risk of scalding.
• Never place the chopper bowls in the microwave
oven.
Food Processor Accessory XL
with Dicer
The food processor accessory with Dicer (12) can
be used for:
• Chopping, blending and mixing Pancake batter;
• slicing, shredding, julienning and making French
fries;
• dicing.
Chopping (E)
Using the blade (12i) you can chop meat, hard
cheese, onions, herbs, garlic, vegetables, bread,
crackers, and nuts.
Refer to the Processing Guide E for maximum
quantities.
Before Use
• Pre-cut foods into small pieces for easier
chopping
• Remove any bones, cartilage, tendons and
gristle from meat to help prevent damage to the
blades.
• Remove stems from herbs, shell nuts.
• Make sure the anti-slip rubber ring (12h) is at-
tached to the bottom of the food processor bowl.
Assembly and Operation
• Carefully remove the chopper blade cover (12j)
from the blade.
• The blade (12i) is very sharp! Always hold it by
the upper plastic part and handle it carefully.
• Place the blade on the center pin of the bowl
(12g). Press it down and give it a turn so that it
locks into place.
• Fill the bowl with food. Insert the splash guard
(12f).
• Then put on the lid (12a) until it engages with a
click.
• Insert the motor part (4) into the coupling (12b)
until it locks.
• Plug in the appliance and insert the pusher (12c)
in the feed tube (12d).
• To operate the food processor, switch on the
appliance. During processing, hold the motor
part with one hand and the food processor bowl
on the handle.
• When chopping is complete, unplug and press
the EasyClick Plus release buttons (5) to detach
the motor part.
• Press the lid latch (12e) to lift up the lid. Then
separate the lid from splash guard.
• Carefully take out the blade before pouring out
the contents of the bowl. To remove and unlock
the blade, slightly turn it then pull it off.
Caution
• Do not use the food processor accessory to
chop extremely hard foods, such as unshelled
nuts, ice cubes, coffee beans, grains or hard
spices e.g. nutmeg. Processing these foods
could damage the blades.
• Never place the food processor bowl in the
microwave oven.
Using the blade (12i), you may also mix pancake
batter based on up to 3 cups / 500 g of flour.
For food processor do not exceed the quantity of
ingredients higher than max line.
Recipe Example: Pancake Batter
3 cups /750 ml milk
3 cups /500 g plain flour
4 eggs
• Pour milk into the bowl, then add flour and finally
the eggs.
• Using full speed, mix the batter until smooth.
Heavier batters or doughs must not be prepared
with the knife. Use the Kneading hook (12k) for
heavier batters and doughs.
Kneading Hook (E)
Figure E also applies for the use of the kneading
hook (12k).
The kneading hook is ideal for kneading different
dough types such as yeast or pastry.
Refer to the Processing Guide Kneading E for maximum
quantities, recommended times and speeds.
Assembly and Operation
• Place the kneading hook on the center pin of the
bowl (12g). Press it down and give it a turn so
that it locks into place.
• Fill the bowl with flour (max. 3 cups /500 g), then
add the other ingredients except the liquids.
• Turn the appliance on at maximum speed.
• Add liquids through the feed tube while the motor
is running.
NOTE: Maximum kneading time: 1 minute – then
allow the motor to cool down for 10 minutes.
Recipe Example: Pizza dough
3 cups / 500 g plain flour
1 tsp salt
1 tsp dried yeast
10 tbsp olive oil
1¼ cups / 300 ml water (lukewarm)
• Put all ingredients except water into the bowl and
start kneading.
• Add water through the feed tube while the motor
is running.
5722114494_HB901-MQ9137XI-9199XL_USCA.indd 21 01.04.21 08:56
Loading ...
Loading ...
Loading ...