Loading ...
Loading ...
Loading ...
49-5000094 Rev. 7 7
ENGLISH
Remote Control Features and Settings
Emergency Operation and Maintenance
18. LIGHT Button
The indoor display panel will show indoor set temperature
by default. Press this button once, it will display the room
temperature. Press this button twice within 3 seconds, it will
turn off the indoor display panel. Press again to go back to
display indoor set temperature.
19. RESET Button
If the remote control is not functioning properly, use a pen point
or a similar object to depress this button to reset the remote.
Emergency Operation
• Use this operation only when the remote control is defective
or lost.
• When the emergency operation switch is pressed, the unit
beeps once, which indicates the start of this operation.
• The unit will run automatically in the following modes:
• During emergency operation, it is not possible to change the
temperature or fan speed. It is also not possible to operate
in timer or dry modes.
Inserting the Batteries
1. Remove the battery cover
2. Insert 2 AAA batteries as
illustrated noting battery
polarity
3. Reinstall the battery cover.
NOTE:
• The distance from the remote
control to the reciever should
be less than 23 feet with no obstructions.
• If the remote control display is weak or the operating
distance has diminished, the batteries may need to be
replaced.
• Remote control malfunctions can sometimes be corrected
by removing the batteries from the remote for a few minutes
and then reinstalling them.
• Remove the batteries from the remote control if the unit will
not be in use for an extended period of time. If any segments
of the display remain active after battery removal, press the
reset button
Optimizing Performance
Wipe the cabinet using a soft and
Cleaning the Front Cover
1. Open the front cover by pulling it upward
2. Remove the Filter:
Gently push up on the filter's center tab until it is released
from the stopper, and remove the
filter in a downward motion.
3. Clean the filter:
Use a vacuum cleaner to remove
dust, or wash the filter with water.
After washing, dry the filter
completely.
4. Attach the filter:
Attach the filter so that the
"FRONT" label is facing outward.
Make sure that the filter is securly
attached behind the holding tabs. If
the filter is not attached correctly
the unit may not achieve maximum
efficiency.
5. Close the front cover.
Check
monthly and
clean if
needed
Beep
emergency
operation switch
** This image only applies to AW09TE2VHA,
AW07TC2HDA, AW09TC2HDA,
AW12TC2HDA, AW18TC2HDA,
AW24TC2HDA, AW18TE2HDA,
AW24TE2HDA & AW12TE2VHA models.
**emergency
operation switch
Loading ...
Loading ...
Loading ...