Loading ...
Loading ...
Loading ...
6 49-5000094 Rev. 7
ENGLISH
Remote Control Features and Settings
11. Louver SIDE/SIDE Button (select models)
• Press the LOUVER SIDE/SIDE button to choose the position
of the vertical airflow louvers.
Status display of air flow
COOL/DRY/HEAT/FAN
NOTE:
• When humidity levels are high, condensate water may occur
at the air outlet if all vertical louvers are adjusted to far left or
right.
• When turning the unit on, the remote control will
automatically return the louver to the previous set position.
12. SLEEP Button
• This SLEEP function automatically adjusts the set
temperature of the heat pump to provide a comfortable
sleeping environment. SLEEP function only available in
COOL, HEAT and AUTO mode. The unit will exit SLEEP
function in the event of pressing SLEEP button again, tuning
off the unit with remote controller or shutting down the
whole system from power outlet. If no other command
chosen during SLEEP function, the unit will shut off itself
after 8 hours of run time. During SLEEP function, the fan
speed can be adjusted to the desired comfort level. The
control logics for SLEEP function will follow as below charts
for different modes:
1. COOL or DRY modes
In Heat Mode
2. Heat Mode
In Heat Mode
13. Fahrenheit/Celcius Button
• Press F/C to toggle remote and unit display temperature
between Fahrenheit and Celsius.
14. EXTRA FUNCTION Button
• Press the EXTRA FUNCTION button to view all other
operations. Press CONFIRM/CANCEL to select and save the
chosen operation. If no button is pressed for 10 seconds,
the remote will exit EXTRA FUNCTION mode.
A) Refresh air - Feature not available on this series.
B) A-B selection - This will allow you to control two separate
units with a single remote control. Note: This feature would
be setup at the time of installation by the contractor.
C) Auto mode - The heat pump will automatically select
Cool, Heat, or Fan operation according to set temperature.
When FAN is set to AUTO the heat pump automatically
adjusts the fan speed according to room temperature.
D) Upper and Lower louver lock.
1. Upper louver lock will lock the horizontal louver in the
top position. Commonly used during cooling.
2. Lower louver lock will lock the horizontal louver in the
lower position. Commonly used during heating.
3. To unlock the louver press EXTRA FUNCTION button until
either a single louver icon or oscillate icon .
Note: When the louver is locked, the position cannot be
changed with the LOUVER UP/DOWN button.
E) Timer ON/OFF: Sets a countdown timer until the unit is
turned ON/OFF. TEMP+/TEMP- button is pressed with the
length of time increment/decrement in 0.5 hour between
0-12 hours,and 1 hour increment/decrement between 12-
24 hours.
1. When the remote is set to ON, the system will turn off
until the countdown timer ends. Then the indoor unit will
turn on and operate in mode, temperature setting and fan
speed that was displayed when timer was set.
2. When the remote is set to OFF, the system will remain ON
until the countdown timer ends.
F) 50°F Heating sets the system to maintain 50°F. This is used
to prevent freezing during long unoccupied periods of time.
15. Confirm/Cancel Button
• Saves and exits the EXTRA FUNCTION selection.
16. HEALTH Button
• Feature is not Available
17. LOCK Button
• Used to lock buttons and LCD display.
Loading ...
Loading ...
Loading ...