Loading ...
Loading ...
Loading ...
English 7
3. Install the floor nozzle.
Install the insert in the floor nozzle.
Connect the floor nozzle to the suction tubes.
Illustration I
Starting up the device
1. Plug the mains plug into the socket.
Illustration J
2. Set the trigger into the desired position.
Illustration K
Position "1 ON": The device is switched on.
Position "0 OFF": The device is switched off.
Operation
ATTENTION
Flat pleated filter missing
Device damage
Always work with the flat pleated filter inserted.
Note
Pay attention to the latest part numbers when purchas-
ing and installing filter bags and flat pleated filters.
Information on accessories and spare parts can be
found at www.kaercher.com.
Dry vacuuming
ATTENTION
Vacuuming cold ashes
Device damage
Only vacuum cold ash with an ash pre-separator.
ATTENTION
Defective or wet flat pleated filter
Device damage
Before initial startup, check the flat pleated filter for
damage and replace it if necessary.
Only vacuum with a dry flat pleated filter.
Note
Replace the filter bag in good time, as a filter bag that is
too full could be damaged. The fill degree of the filter
bag depends on the amount of dirt vacuumed. The filter
bag should be replaced more frequently when vacuum-
ing fine dust, sand, etc.
Wet vacuuming
ATTENTION
Wet vacuuming with a filter bag
Device damage
Do not use a filter bag when vacuuming wet.
ATTENTION
Operation with full container
When the container is full, a float switch closes the suc-
tion opening and the device runs at a higher speed.
Switch off the device immediately and empty the con-
tainer.
Note
If the device falls over, the float can also close. To make the
device capable of vacuuming again, set up the device,
switch it off, wait 5 seconds and then switch it on again.
Interrupting operation
1. Set the trigger to "0 OFF".
The device is switched off.
2. Variant 1: Place the handle of the suction hose in the
intermediate parking position.
Illustration L
Variant 2: Attach the floor nozzle in the parking po-
sition
.
Illustration M
Ending operation
1. Set the trigger to "0 OFF".
The device is switched off.
2. Pull out the mains plug.
3. Remove the device head.
Illustration B
4. Empty the container.
Illustration N
5. Storage possibility:
Illustration U
Note
The suction hose can be wrapped around the device
head and attached to the device head with the help of
the hose collar.
6. Store the device in a dry and frost-proof room.
Care and service
General care instructions
Clean the device and plastic accessory parts with a
commonly available plastic cleaner.
Rinse the container and accessories with water, as
necessary, and dry them before further use.
Clean the filter box / flat pleated filter
1. Unlock the filter box and fold it out.
Illustration O
2. Remove the filter box.
Illustration P
3. Empty the filter box into a waste container. In the
case of heavy soiling, tap the filter box against the
edge of the waste container. The flat pleated filter
does not have to be removed from the filter box.
Illustration Q
If necessary, clean the flat pleated filter separately.
4. To do this, remove the flat pleated filter from the filter
box.
Illustration R
5. Clean the flat pleated filter under running water. Do
not rub or brush off.
Illustration S
6. Allow the flat pleated filter to dry completely before
reusing.
Illustration T
Note
We recommend cleaning the flat pleated filter after each
use.
Troubleshooting guide
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
Declining suction performance
Accessories, the suction hose or the suction tubes are
clogged.
Remove the clog with a suitable aid.
The filter bag is full
Replace the filter bag.
The flat pleated filter is dirty.
Clean the flat pleated filter (see Chapter Clean the
filter box / flat pleated filter).
The flat pleated filter is damaged.
Replace the flat pleated filter.
Technical data
Note
The technical data can be found on the type plate.
Loading ...