Loading ...
Loading ...
Loading ...
EDGING TIPS
1. Move edger to a desired area to begin edging, making sure
that the left rear wheel is on a hard surface and the blade is
over area to be cut.
2. Lower blade control lever to achieve depth of cut desired.
The further the forward blade depth control lever is moved,
the deeper or lower the blade will cut into the ground.
3. For newly edged lawns, multiple passes may be needed to
achieve desired depth by lowering depth of cut incrementally.
4. For best results, proceed slowly along the path being edged.
Slowly moving edger forward and backward through cutting
area, making sure to keep the left rear wheel on the hard
surface and the blade in the cutting path, close to but not
touching the edge of the hard surface.
5. Once you have nished edging selected area, raise the blade
control lever back in to the TOP position, move to the next
area to be edged, and proceed again from step 1.
Use this guide to determine slope angle. Do Not
edge on a slope greater than 15 degrees.
A 10 degree slope is a hill that increases in height at
approximately 1.76 feet (53.6 CM) in 10 feet (304.5 CM).
A 15 degree slope is a hill that increases in height at
approximately 2.68 feet (81.7 cm) in 10 feet (304.5 cm).
WARNING
USE EXTREME CARE AT ALL TIMES AND AVOID
SUDDEN TURNS OR MANEUVERS. FOLLOW OTHER
INSTRUCTIONS IN THIS MANUAL FOR SAFETY IN
EDGING ON SLOPES. USE EXTRA CARE WHEN OPER
ATING ON OR NEAR SLOPES AND OBSTRUCTIONS.
SLOPE GUIDE
WARNING!
ROTATING CUTTING BLADE MAY THROW OBJECTS
CAUSING PERSONAL INJURY. KEEP AREA CLEAR
OF BYSTANDERS AND DO NOT OPERATE WITHOUT
GUARDS IN PLACE.
WARNING!
DO NOT LOWER BLADE IF BLADE IS OVER CONCRETE,
ASPHALT, ROCKS OR THE LIKE. BLADE CAN STRIKE
SUPPORTING SURFACE, RESULTING IN PERSONAL IN
JURY OR PROPERTY DAMAGE.
Operator’s Manual
Edger
For additional information visit online at www.brutepower.com or call 800-743-4115 M-F 8-5 CST
14
Loading ...
Loading ...
Loading ...