Loading ...
Loading ...
Loading ...
6
6
8. Fix the switch box (No.11 and No.15) under the sewn strap and knot the other strap around the switch box.
(Figure F & Figure G).
9. Loosen the waist belt latch and chest belt latch. In an open area, lift the vacuum by one shoulder strap and
slide your free arm into the other strap. (Figure D)
10. Adjust the shoulder straps to allow the waist belt to be buckled around your waist.
11. Fasten the waist belt and chest belt snugly and make sure the weight is resting comfortably on your hips.
NOTE: The back-plate can be adjusted up or down by removing the four screws (No.27) that attach to the
vacuum’s body. (Figure H)
12. Attach tools to the handle and make sure the two ends are tightly connected. (Figure I)
PROPER VACUUMING MOTION FOR LARGE AREA WITH DIRECT
SUCTION TOOLS
1. Begin with the wand parallel to your body.
2. Draw the top of the wand in towards your waist and twist at the waist walking back and forward (a side-to-
side motion).
3. The motion is similar to mopping and keeps the upper body and arms from tiring.
MAINTENANCE INSTRUCTION
! WARNING: The following information is for use by qualified service personnel only and
is to provide guidance for troubleshooting and maintenance.
◆ UNPLUG the vacuum when working on the motor or any electrical part.
◆ CHECK the condition of all electrical cords before each use.
◆ DO NOT lubricate the motor; it is equipped with sealed bearings.
◆ The appliance has NO user serviceable parts.
PROPER STORAGE
When the vacuum is not in use, it should be stored in a dry place
ELECTRICAL CORD CARE
NEVER stretch the cord tightly between the vacuum and the outlet. A cord that is stretched or pulled will not
function properly and creates a hazard.
After vacuuming, unplug the cord and wind it up loosely. DO NOT wind the cord up by wrapping it around your
Loading ...
Loading ...