Loading ...
Loading ...
Loading ...
5
5
PREPARATION FOR OPERATION
1. Remove the cover (No. 34) and cover seal ring (No. 33) and pull out the cloth dust bag (No. 31). Check to
see that the filter guards and filter (No. 1, No. 2 and No.3) have not shifted during shipping. (Figure A)
2. Install an inner paper dust bag (No. 32) inside of the outer cloth dust bag (No. 31). At the beginning of
each shift, the bags should be checked. Empty or replace as necessary. The unit comes with 5 extra bags
and additional bags are readily available for purchase.
NOTE: Never use a paper dust bag without the cloth dust bag.
3. Place the cover seal ring (No. 33) on the dust bag’s opening (No. 32).(Figure B)
4. Replace the cover (No. 34) and clip the sunken edge of the cover tight by pushing downward on the cover
clip (No.7).
5. Push the bent connector tube (No. 35) into the cover (No34), make sure that it inserts into the cover (No.
34) completely and tightly (Figure C).
6. Check the hose ends to make sure that they fit tightly. In the event a hose end comes apart from the hose,
the hose can simply be rethreaded into the hose end.
7. Check the wear on the cord by the vacuum body and at the plug. Pass the power supply cord (No.13) through
the strip outside the left side of the waist belt (Figure E).
Loading ...
Loading ...
Loading ...