Loading ...
Loading ...
Loading ...
Mostlaunderingproblemsareeasily
solvedifyouunderstandthecause.
Checktheselistsforcommonlaundry
andwasherproblems.Ifyouneed
furtherassistance,seepage36.
Problem Possible Cause Solution
Washer Leaks Household plumbing isleaking. Repair plumbing.
Inlet hoses not tight. Tighten hoses (see "INSTALLATION_'
Sections D & E).
Inlet hose washers not Reseat washers
properly seated. (see "INSTALLATION;' Section D).
Drain hose not properly Clamp drain hose
clamped or is off. (see "INSTALLATION_' Section C).
Drain is clogged. Remove drain clogs. Sink, standpipe,
or floor drain must be able to handle
17 gallons of water per minute.
Tub moved forward during Ensure tub is centered before
unloading, causing water starting washer.
to deflect off of tub ring.
Unit not level causing water
to deflect off of tub ring.
Ensure front feet are installed and
nuts are tightened. Level washer.
Reset rear legs (see "INSTALLATION,"
Section G).
Load is unbalanced. Spray Redistribute the load.
rinses are deflecting off of load.
Washer is overloaded. Fills Reduce load size.
o_spray rinses are deflecting
off of toad.
Won't Drain/
Won't Spin/
Wet Loads
Drain hose is kinked
or clogged.
Straighten or unplug hose
(see "INSTALLATION;' Section C).
Correct operation of After a wash or rinse, the washer will
neutral drain, drain without spinning. After draining.
the spinning begins.
Lid is open. Close the lid.
Drain hose is more than Lower drain hose
96 inches above floor. (see "INSTALLATION," Section C).
Too much detergent - Use less detergent.
excessive sudsing.
Wrong cycle for load Choose a cycle with a higher spin
being washed, speed (see "OPERATION").
31
Loading ...
Loading ...
Loading ...