Loading ...
Loading ...
Loading ...
10
Operation
Operating the Rollover does not require any specific skills of the operator. The operation is performed as
described in this manual. Please note: The PVC-cutting mat can be somewhat “uneven” and the
surface might after some use be worn out – this can affect the quality of applications negatively. In
such cases, application can be done directly on the glass bed until the mat has been replaced.
Remember to use only stainless-steel blades if cutting directly on the glass.
Application of self-adhesive vinyl and laminate
1. For application on thicker materials, i.e. sheets which are raising from the glass bed, the substrate is
best placed centered on the bed. If the sheet is placed on one side, counterbalance must be achieved by
placing material having the same thickness at the opposite side, enabling the roller to hit evenly when
lowered onto the substrate.
2. For application on a hollow or box-shaped subject, i.e. road sign or a box lid, a support piece of
polystyrene or similar must be placed inside the hollow enabling the subject to resist the pressure from
the roller. Please remember to position centered on the tabletop or provide the same build-up on both
sides.
**The thickness of the material can max. be the same as the gap between roller and table top (60mm).
The pressure from the roller when applying will remain unaffected by the thickness of the material within
this range.
3. Place the media onto the substrate exactly in the position where you want it to be applied.
4. Lower the roller about a foot or so from one end of the substrate by pressing the activation switch at
the end of the handle. This will lock the media in the chosen position.
5. Flip the short end of the media over the roller and remove the back paper
7. Cut off or fold the back paper, leaving about 5 – 6 inches innermost against the roller.
8. If cut, fold a couple of inches of the back paper downwards towards the roller forming a straight fold.
9. Bring the roller over the substrate applying the media in the correct position. When applying on
thicker substrates, place a piece of similar thickness against the end preventing the roller to fall off the
edge and slam against the glass bed. Please pay attention to keeping the media straight over the roller
as you go.
10. Lift and place the roller where the back paper is cut off.
11. Turn the remaining part of the media over the roller.
Loading ...
Loading ...
Loading ...