Loading ...
Loading ...
Loading ...
27
26
Fault phenomenon
Recommended handling method
The dryer is too loud.
Look for coins, loose buttons, nails, and other
objects and remove them immediately.
Check the lint filter. Remove any items stuck
inside the lint filter.
Make sure the dryer is level and standing firmly
on the floor.
The dryer may hum due to air moving through
the drum and fan. This is normal.
Clothes are shrinking.
Garment care instructions are not being followed.
Use a low or no heat setting.
Lint is left on clothes.
Lint filter has not been cleaned properly.
Clothes have not been sorted properly.
Tissue, paper, etc., has been left in pockets.
Some fabrics cause more lint and should be dried
separately from fabrics that lint attaches easily.
The appliance has an
odour.
The smell is caused by rubber material that is
attached to the appliance inside. This kind of smell is
a rubber's own smell and disappears automatically
after using the appliance several times.
When washing the clothes, use the detergent in
accordance with the manufacturers
recommendations. If you use the detergent
excessively not according to the recommendations,
undissolved detergent may accumulate on the
clothes and cause an odour.
You can smell odours from the clothes if the clothes
were left in the appliance after drying or in the
washing machine after washing. Unload the clothes
promptly at the end of the drying or washing cycle.
Ensure you can smell same odour in the washing
machine. If so, clean the tub of the washing machine
referring to the washing machine user manual.
Always take care of both lint filters clean. If any
residues were left in the lint filter after drying, it may
cause odours. And also dry the lint filter completely
after cleaning.
F40
Interpretation
Compressor
protection
F50/F51
F21
Recommended handling method
Rotate the knob to "Off" to shut down the dryer, and
restart it after the compressor cools down.
If the abnormality is not removed, please contact
after-sales service.
Check whether the drain pipe is frozen, knotted or
blocked.
Check whether the drain pump is blocked.
If the abnormality is not removed, please contact
after-sales service.
F41
Abnormal display
panel and the
power board
Rotate the knob to "Off" to shut down the dryer, and
restart it after 10 seconds.
If the abnormality is not removed, please contact
after-sales service.
Code
Abnormal drain
pump or float
switch
Abnormal sensor
Please contact after-sales service.
Information codes
Loading ...