Loading ...
Loading ...
3
INSTALLATION INSTRUCTIONS
Unpack the Refrigerator
Remove the Packaging
IMPORTANT: Do not remove the white foam air return insert
from behind the control panel on the ceiling of the refrigerator.
If the insert is removed, ice may migrate down from the freezer
and cause icicles to form.
1. Remove tape and glue residue from surfaces before turning
on the refrigerator. Rub a small amount of liquid dish soap
over the adhesive with your ngers. Rinse with warm water
and dry with a soft cloth.
NOTE: Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove tape or
glue. These products can damage the surface of your
refrigerator. For more information see “Refrigerator Safety”.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator for
cleaning or service, be sure to cover the oor with cardboard
or hardboard to avoid oor damage. Always pull the refrigerator
straight out when moving it. Do not wiggle or “walk” the
refrigerator when trying to move it, as oor damage could occur.
Install Levelers
IMPORTANT: Lay down the refrigerator ONLY to your left-hand
side (as you are looking at the front of the refrigerator) to avoid
damaging the refrigerator.
1. Locate the levelers. They are enclosed in a plastic bag inside
the crisper drawer.
2. Using two or more people, access the bottom of the
refrigerator either by tilting it rst to one side and then the
other or by laying it down on the oor to your left-hand side
as shown.
■ Tilt the refrigerator to the side enough to access the
bottom. Using a 3/8" hex driver, remove the two screws
attaching the wooden runner to the bottom of the
refrigerator. Then install a leveler to the front corner.
Repeat for the opposite side.
NOTE: The refrigerator cabinet should not touch the floor
without a leveler installed.
OR
■ Using the packaging corner posts (left-hand side, front and
back) as a cushion, lay the refrigerator down on the floor (to
your left-hand side only) as shown in the following graphic.
NOTE: Using the packaging as a cushion will help to avoid
possible damage to the refrigerator.
■ Using a 3/8" hex driver, remove the two screws attaching
each wooden runner to the bottom of the refrigerator. Install
a leveler to each of the front corners.
Clean Before Using
After you remove all of the package materials, clean the inside of
your refrigerator before using it. See the cleaning instructions in
“Refrigerator Care.”
Important information to know about glass shelves and
covers:
Do not clean glass shelves or covers with warm water when they
are cold. Shelves and covers may break if exposed to sudden
temperature changes or impact, such as bumping. Tempered
glass is designed to shatter into many small, pebble-size pieces.
This is normal. Glass shelves and covers are heavy. Use both
hands when removing them to avoid dropping.
INSTALLING YOUR FREEZER
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
BA
A. Remove runner.
B. Install leveler.
BA
C
A. Remove runner.
B. Install leveler.
C. Packaging corner post.
Loading ...
Loading ...
Loading ...