Loading ...
Loading ...
Loading ...
Installation Instructions
WHAT YOU WILL NEED (CONT.)
NOTE: The onlg GE approved plastic tubing
is that supplied in GE SmartConnect"
Refrigerator Tubing kits. Do not use ang other
plastic water supplg line because the line is
under pressure at all times. Certain tgpes of
plastic will crack or rupture with age and cause
water damage to gour home.
• A GE water supplg kit (containing tubing,
shutoff valve and fittings listed below) is available
at extra cost from your dealer or from Parts and
Accessories, 800.626.2002 (in Canada
1.888.261.3055).
• A cold water supplg. The water pressure must
be between 20 and 120 p.s.i. (1.4-8.1 bar).
• Power drill.
• 1/2" or adjustable wrench.
° Straight and Phillips blade screwdriver.
° Two 1/4" outer diameter compression nuts
and 2 ferrules (sleeves)--to connect the copper
tubing to the shutoff valve and the refrigerator
water valve.
OR
° If you are using a GE SmartConnect T"
Refrigerator Tubing kit, the necessary fittings
are preassembled to the tubing.
• If your existing copper water line has aflared
fitting at the end, you will need an adapter
(available at plumbing supply stores) to connect
the water line to the refrigerator OR you can cut
off the flared fitting with a tube cutter and then
use a compression fitting. Do not cut formed end
from GE SmartConnecf" Refrigerator tubing.
° Shutoff valve to connect to the cold water line.
The shutoff valve should have a water inlet with
a minimum inside diameter of 5/32" at the point
of connection to the COLD WATER LINE. Saddle-
type shutoff valves are included in many water
supplg kits. Before purchasing, make sure a
saddle-type valve complies with your local
plumbing codes.
Install the shutoff valve on the nearest frequentlg
used drinking water line.
SHUT OFF THE MAIN WATER SUPPLY
Turn on the nearest faucet long enough
to clear the line of water.
[] CHOOSE THE VALVE LOCATION
Choose a location for the valve that is easilg
accessible, It is best to connect into the side
of a vertical water pipe. When it is necessary
to connect into a horizontal water pipe, make
the connection to the top or side, rather than at
the bottom, to avoid drawing off any sediment
from the water pipe.
[] DRILL THE HOLE FOR THE VALVE
Drill a1/4" hole in the water pipe (even if using
a self-piercing valve), using a sharp bit. Remove
any burrs resulting from drilling the hole in
the pipe.
Take care not to allow water to drain into the
drill.
Failure to drill a1/4" hole may result in reduced
ice production or smaller cubes.
29
Loading ...
Loading ...
Loading ...