Loading ...
Loading ...
Loading ...
General Cleaning
(continued)
Figure 1
Support posts
_1 provided with
_ spice rack
Some models are equipped with an optional spice rack. To mount the rack to
the range refer to your Installation Instructions.
To Clean the Spice Rack (some models)
1. Remove all the spices from the spice rack.
2. Lift up on the bottom of the spice rack to remove it from the support posts.
3. Using a mild dish detergent, clean the spice rack. Cover stubborn spots
with an ammonia-soaked paper towel for 30 to 40 minutes. Cleaners made
especially for stainless steel, chrome or copper are also recommended.
4. Rinse off all cleaners with clean water and a cloth.
5. Wipe dry before operating the range. Bluish stains may result due to heat
combining with the cleaning material; these stains cannot be removed.
To
1.
Reinstall the Spice Rack (some models)
Place the spice rack on top of the support posts. Make sure the top lip hooks
over the top of the support posts and the side flanges are around the side
of the support posts as shown in the diagram in Figure 1.
Changing Cooktop
and/or Oven Lights
(some models)
Be sure the range is unplugged and all parts are COOL before
replacing the oven light. Wear a leather-faced glove for protection against
possible broken glass.
To Change the Oven Light (some models)
On some models, the oven light automatically turns on when the door is
opened. Some models have a switch located on the control panel to turn on
the light. The oven light is located at the rear of the oven and is covered with
a glass shield held by a wire holder. The glass shield must be in place whenever
the oven is in use.
To replace the oven light:
1. Turn electrical power off at the main source or unplug the range.
2. Press wire holder to one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder into place.
5. Turn power back on again at the main source (or plug the range back in).
6. The clock(if equipped) will then need to be reset. To reset, see Setting the
Clock and Minute Timer in this Owner's Guide.
2O
Loading ...
Loading ...
Loading ...