Loading ...
Loading ...
Loading ...
10.1.3 Dismantling the Top valve
To dismantle this valve, undo the valve screw with integral pressure indicator (2)
on the lid indside using a screwdriver.
1 Counter nut
2 Pressure indicator
3 Valve spring
4 Valve seal
5 Valve socket
6 Valve cap with
integral pressure
indicator
10.1.4 Cleaning and re-assembling the valve
1. Disassemble the valve and clean it. Never use any abrasive cleaners.
2. During re-assembly, ensure that the valve cap is securely fastened to
the pressure indicator stem and that the valve screw has been fully tightened by
hand.
3.Check for proper valve operation after assembly. (See section 6)
10.1.5 Fitting the SI valve (secondary safety device)
Press the valve in by hand from the inside of the lid.
Check:
Blue rubber seal must fit tightly against the
lid, all the way around, on the outside and
inside of the lid.
Lid inside Spring must be visible on the inside of the lid.
10.2 Additional cleaning and care instructions for the
DUROMATIC non-stick coating
Apart from the general cleaning and care references in section 10 are following
references to be considered.
Do not use any abrasive cleaning agents or SWISS CLEANER to
clean the hard titanium base non-stick coating.
Wash the coating immediately after use, i.e. when the pan is still warm, with
warm water and washing-up liquid so that no residues become hardened.
This also retains the non-stick effect and prevents any residual oils or fats from
being burnt on.
Loading ...
Loading ...
Loading ...