Loading ...
Loading ...
Loading ...
14 OPERATING INSTRUCTIONS
NOTE
TO TURN UNIT ON:
PRESS ON/OFF BUTTON
DO THIS:
YOU WILL SEE:
NOTE: The unit will run in Eco(energy saver)
mode when powered on each time. In this
mode, the fan will continue to run for 3
minutes after compressor shuts o. The fan
then cycles on for 120 seconds at 10 minute
intervals until the room temperature is above
the set temperature, at which time the
compressor turns back on.
TO CHANGE TEMPERATURE SETTING:
PRESS TO RAISE
PRESS TO LOWER
DO THIS:
YOU WILL SEE:
YOU WILL SEE:
TO USE AUTO FAN FEATURE:
DO THIS:
PRESS FAN BUTTON,
CHOOSE AUTO
TO ADJUST FAN SPEEDS:
DO THIS:
PRESS TO SELECT
The following instructions are for the
control panel. The same instructions can be
used for the remote control.
The display will show the set temperature
during normal operation, press either up ( + )
or down ( – ) buttons to adjust the
temperature to desired setting. If the up ( + )
or down ( – ) button is pressed continuously,
the unit will beep twice when the
temperature setting reaches the upper/lower
limits 90°F or 60°F.
Loading ...
Loading ...
Loading ...