Loading ...
Loading ...
Loading ...
I NSTALLATI 0 N
• Lift left side refrigerator door, along with top
hinge, from center hinge pin.
• Remove center hinge pin with a _6" hex head
driver and retain hinge pin for later use.
8. Remove Phillips screws to .._
remove right and left hinges
and retain all screws for later
use.
9. Remove both stabilizing
brackets with _/8"hex head
driver and retain screws for
later use.
Pullout Freezer Drawer
(select models)
5. Lift top of drawer front to
unhook the drawer from
the slides. Lift door front
out to remove.
To Install:
1. Pull both rails out to
full extension.
2. While supporting
door front, hook
supports into slots
located on inside of
each slide.
Note: All four drawer bracket supports must be in
the proper slots for the drawer to function properly.
Materials Needed:
\
/
• Phillips screwdriver
To Remove:
1. Pull drawer open to full
extension.
2. Tilt the lower basket
forward and lift to remove.
, On each white drawer
bracket is a basket cradle
with two snap attachments.
To release each cradle,
unlatch the snaps by
pushing them inward, away from the side bracket.
Lift the cradles off of the rails.
4. Remove Phillips screw from each of the drawer
slides (select models).
,
4.
,
Lower door front into final position.
Replace and tighten Phillips screws that were
removed from the drawer slides (select models).
Place the basket cradles back onto the drawer
slides. Align basket cradle snaps with the slots on
the drawer brackets and press each cradle toward
the bracket until it clicks.
Basket cradle
6. Tilt the lower basket front down and set it down
into the basket cradles.
Loading ...
Loading ...
Loading ...