Loading ...
Loading ...
Loading ...
Panel and LCD
All the controller adjustment displays on the LCD, and all the detection
results are also shown on the LCD. LCD See Fig.6
● Mode indication cursor: Indicate the four kinds of operation modes. Make a
switch through the MODE button.
● Target ID pattern: It’s located above the LCD screen. It indicates the target
metal you’re looking for. When detecting a metal target, the target ID cursor
(upper scale) shows the metal patterns or the words.
● Target ID cursor (upper scale): it’s in the shape of .The upper scale
consists of 6 segments. When the target ID cursor is lighted, this indicates
the probable type of the detected metal.
The three kinds of prompted signal, corresponding to the target ID cursor.
See the table below:
Note: The position of the target ID cursor may change as it is affected by the
soil composition and the same material metal have in different soil.
● Target identification cursor (lower scale): It’s in the shape of,6 segments
making up the lower cursor, which indicates the material types of the
detected target objects. In the ALL-METAL mode, the 6 segments are all
lighted. While in other modes, when a certain target identification cursor is
extinguished, which indicates this type of metal isn’t in the detection range,
which means this type of metal is eliminated. In the PINPOINT mode, the
Target identification cursor is useless.
Fig.6
Low pitch Mediant High pitch
IRON
5￠,
S-cap
1￠,10￠,25￠,50￠
Loading ...
Loading ...
Loading ...