Loading ...
Loading ...
Loading ...
31
B. Cleaning and Sanitizing Instructions
The icemaker must be cleaned and sanitized at least twice a year. More frequent
cleaning and sanitizing may be required in some conditions.
WARNING
• To prevent injury to individuals and damage to the icemaker, do not use ammonia
type cleaners.
• Carefully follow any instructions provided with the bottles of cleaning and
sanitizing solution.
• Always wear liquid-proof gloves and goggles to prevent the cleaning and sanitizing
solutions from coming into contact with skin or eyes.
• After cleaning and sanitizing, do not use ice made from the cleaning and sanitizing
solutions. Be careful not to leave any solution on the parts or in the dispenser
unit/ice storage bin.
1. Cleaning Procedure
1) Dilute 9.6 . oz. (0.29 l) of Hoshizaki "Scale Away" with 1.6 gal. (6.0 l) of warm water.
IMPORTANT! For safety and maximum effectiveness, use the solution immediately
after dilution.
2) Close the water supply line shut-off valve. Remove the front panel, then move the power
switch to the "OFF" position. Move the control switch to the "DRAIN" position, then
move the power switch back to the "ON" position. Replace the front panel in its correct
position.
3) Allow the water system to drain for 5 minutes.
4) Remove the front panel. Move the power switch to the "OFF" position, then unplug the
unit from the electrical outlet. Remove the top panel.
5) Remove all of the ice from the dispenser unit/ice storage bin.
6) Remove the strap connecting the spout to the chute assembly, then remove the spout.
See Fig. 12.
7) Pour the cleaning solution over the extruding head until the evaporator assembly and
the reservoir are full and the solution starts to overow into the drain pan.
Note: If there is excess scale on the extruding head, ll the evaporator assembly and
reservoir as described above, then use a clamp on the reservoir hose between
the reservoir and evaporator assembly to block ow. Pour additional cleaning
solution over the extruding head until the evaporator assembly is completely full.
8) Replace the spout and strap in their correct positions.
9) Allow the icemaker to sit for about 10 minutes before operation. If you placed a clamp on
the reservoir hose in step 7, remove it before operation.
Loading ...
Loading ...
Loading ...