Loading ...
Loading ...
Loading ...
ge.com
Burner Caps and Heads
Burner caps Replacement
Lift offwhel] cool. _'ash burlier caps Replace tile burlier heads aim caps. Make
in hot, soapy water aim rinse with clean sure that tile heads aim caps are replaced
water. You Ill;IV, scotlr with a l)lasfic scot/ling+ ill the COITect loc;ItiOl]. There is one oxal
pad to reiuove btiri_ed-oi_ fi)od particles. (center) head aim cap asseIubly aim fi)ur
. - nleditun (side) heads aim caps.
uurner neao:
For proper igIfition, Inake sure the Mediurn burner Mediurn burner
• , rn y
or wire twist-tie works well to ui]clog it
to unclog the small hole in the r _ , , , _ ] _ I I _ ]
h0a Clo ed.i b,ii ,eip.its ,,ie e/tI,, es I I'1 I
; ". ". , _ Frontof range A
electrode with ;invthln_ hard or it could / . I
• ' Medmmburner Medmmburner
be daInaged, headandcap headandcap
You should clean the bt/l'nel" ca/is and
• . _ Make sure the sh>t iI] the burI]er head is
burI]er heads routn]elv, especially after bad , ,
• , ' * ' , poSltloI]ed over tile electrode.
slMh)veIs, which could clog, the ol)ei]ii]gs,
in the burner heads. Liti off when cool.
To remove buri_ed-ln_ fi)od, soak the
burner heads in a soluti(m of inild liquid
detergent ai]d hot water fi)r 20-30 miI]utes.
FoI" ii]oi'e SttlbboFi] stnins, use a toothbrush.
NOTE:Donotusesteelwoolorscounngpowders
tocleantheburners.
After cleaning
geloI'e putting the buri]er caps aI]d heads
back, shake out excess water aI]d then dry
them thoroughly by setting in a wamI oven
ti)I" 30 miI]utes.
21
Loading ...
Loading ...
Loading ...