Loading ...
Loading ...
Loading ...
©2018 DreamLine. All Rights Reserved
24ENIGMA-XO manual Ver 1 Rev 2 03/2018
Note: If installing
the 72” model,
position the door-side
stopper so that the
handle cannot make
contact with the small
inline panel glass
when the door is in
the closed position.
Fig 24a
3”
wall
(+/- 1/8”)
Fig 24b
!
3
2
Stopper
hole
1
Stopper
Thread Lock
Panel side
Stopper (#01)
4
Door side
Thread
Lock
72” model with Right hand
door installation
!
door side of opening
48” and 60” models
approximately
(ENIGMA-XO Right hand door
installation shown as an example)
5
6
7*
small
panel
position stopper
to allow enough
clearance for the
handle
Door Stopper Installation:
1. Remove the set screw
2. Slide the Door Stopper (#01) onto the Upper Guide Rail (#03)
3. Align with stopper hole (stationary panel side only)
4. Apply Thread Lock Adhesive (#26) to the set screw threads
5. Tighten screw into the stopper hole (stationary panel side only)
6. Correctly position the door side stopper and tighten the set screw with Thread Lock Adhesive (#26)
(Fig. 24b)
24. Position the Door Stoppers (#01) and screw
them tightly to the Upper Guide Rail (#03).
NOTE: The Door Stoppers (#01) must be
positioned correctly to prevent the handle from contacting the
Stationary Glass (#02) (48”, 60” & 72“ models) and to stop the
Door Glass (#05) in a position that allows the bumper strip to
create a seal with the wall, but does not allow the door glass to
bang into the wall during normal operation (48” & 60” models).
(Fig 24a 24b)
*For the 72” model: Install the door side stopper in a position to
prevent the handle from making contact with the small inline
panel glass when the door is in the closed position. (Fig
24b.7)
Loading ...
Loading ...
Loading ...