Loading ...
Loading ...
Loading ...
WARNING
Disconnectthe
spark plug wire
and ground it
against the engine
to prevent
unintendedstarting.
Do not use the
chute handle to lift
the snow thrower.
Referto the tire's
sidewallfor proper
PSiinflation.Equal
tirepressureshould
bemaintainedat all
times.Excessive
i pressurewhenseat=
ingbeadsmay cause
tire/rimassembly
to burstwithforce
sufficient to cause
seriousinjury.
NOTEI
All references toleft
or right side of the
snow thrower is
operating
position only.
IMPORTANT:Thisunit isshippedwith the enginefull of
oil. Afterassembly,seepage 9 for fuel and oil details.
Before Assembly
_ WARNING:Disconnectthe spark plug
wire and Ground it against the engine
to prevent unintended starting.
NOTE:Referenceto right,left,frontor rear ofthe unitis
fromtheoperatingpositionunlessotherwisestated.
1. Cutthe cabletie that securesthe upper handleto
the chuteassemblyfor shippingpurposes.
Setting Up The Handle
1. Loosenthe chuteknobon theupperchute(l) and
pivotthe upperchuteupwards(2)as faras it willgo.
SeeFigure1.
,_ WARNING:Do not lift the snow thrower by
the chute handle.
Chute Handle
Figure 1
J
2. Loosenthe handleknob, saddlewasherandhandle
tab oneachside of the handle.See Figure2.
3. Holdboth controlsagainstupperhandleand pull up
as shownin Step1 of Figure3. Makesurethat the
upperhandlelocksoverthe lowerhandle and handle
tabsalign with the handle.Youmay haveto carefully
maneuverthe upperhandleto clearchuteassembly.
CAUTION:Be careful not to bend or kink the cable.
4. Tightenthe handleknobsoneach sideof the
handle.Referto Step2 inFigure3.
5. Adjustupperchuteand rotatechute handleto
desiredoperatingposition.
6. Tightenthechuteknobon the upperchute making
surethe flatwasherandthe carriagebolt are
correctlypositioned.Referto Figure1.
f
Clean-Out Tool
Thistoolandthe electricextensioncord, if so equipped,
maybe fastenedwith a cabletie to the rear of the auger
housingfor shippingpurposes.In thatcase,cutthe
cabletie and removetheextensioncord now.
Figure 2
Final Adjustments
IMPORTANT:Checktheadjustmentsas instructedand
makeany finaladjustmentsnecessarybeforeoperating
the unit.Checkall nuts and bolts for tightness.Failureto
followtheseinstructionsmay causedamageto unit.
Tire Pressure (Pneumatic Tires)
Thetiresareover-inflatedforshippingpurposes.Check
tirepressureand reducepressure,if needed.Referto
thetire'ssidewallfortheproperinflationPSiinformation.
Maintainequalpressureonbothwheelsof snowthrower.
WARNING:Referto the tire's sidewall
A or properPSiinflation.Equal tire
pressureshould be maintained at
all times. Excessive pressurewhen
seating beads may cause tire/rim
assembly to burst with force sufficient
Figure 3
6
Loading ...
Loading ...
Loading ...