Loading ...
Loading ...
Loading ...
RightAngleAttachment53002
Beforeyou begin, removethe black protective capon
your attachment.If cap doesnot slideoff easily,insert
the shankportion of anyaccessory through the
housing openingof the attachmentto hold shaftfrom
rotating. Thentwist off. Figure1.
Do not use the rotary !ool shaft
lock button when changing
accessorieson the attachment. Internal damage to
the attachmentmayoccur.
Removethe housing capfrom your existing rotary
tool as shown in Jig.2.Thenpressthe shaft _ock
button on your rotary tool, unscrew thecollet nut and
removethe collet.
Setyour collet nut andcollet asideit will be
reinstalledlater in step 4.
Install the drive adapter,included with your right
angle attachment,on themotor shaft asshown in
fig.3 andtighten.
Donotover tightendrive
adapter. Tighten the driveadapter
finger tight and thentighten anadditional 1/3turn
with the wrench.(Wrench included with your rotary
tool kit)
/
Screw theattachmentonto your rotarytool. Hand
tighten only.Reassemblethe collet andthecollet nut
from step2, onto the outputshaft ofthe attachment.
Figure4.
Theright angle attachmentcan beorientedon your
rotary tool in 12 different positions. Theattachment
shouldbepositionedso the on/off speedcontrol
switch iseasyto access.
To reposition, unscrewthecollar from theattachment
untildisengaged.Slidethe attachmentoff. Then,
reposition,slide theattachment backonthetool and
retightenthecollar. Figure5.
To changean accessory,insert theshankportion of
anyaccessory(3,2 mm recommended)through the
housing openingof the attachmentto hold the shaft
from rotating.With the shaftsecured,loosenthe
collet nut andinsert an accessoryas deeplyas
possibleto avoidwobbleduring use.You may needt(
pull backtheshank from thehousing openingto
provide clearancewhile insertingtheaccessory.
Figure6.
_ Attachmentcanbecomehotafte
prolongusage.
2O
Loading ...
Loading ...
Loading ...