Loading ...
Loading ...
Loading ...
12
8. Replace the chain/sprocket end cover by positioning the
cover onto the saw head. Tighten the end cover knob,
but leave the bar free to move for tension adjustment.
Put back the hex bolt by screwing it clockwise with the
hex key wrench.
9. Remove all slack from the chain by turning the chain
tensioner ring clockwise until the chain seats snugly
against the bar with the drive links in the bar groove
(Fig. 12).
NOTE: The chain is correctly tensioned when there is no
sag on the underside of the guide bar; the chain is snug,
but can be rotated by hand without binding. For more
information on chain tensioning, see the maintenance
section beginning on pg. 17.
Connecting to the Telescoping Pole
1. Open the assembly lock on the telescoping pole, and
push the chain saw head into the opening on the end of
the pole (Fig. 13).
2. When the lock tabs snap in, lock back the assembly lock,
the pole chain saw will be ready to use (Fig. 14).
3. To remove the chain saw head, release the On/O trigger
switch and remove the battery. Unlock the assembly lock.
Push the lock tabs on both sides, and pull the chain saw
head out.
R
Sprocket
Adjusting pin
Chain tension
pin hole
Fig. 11
R
Fig. 12
Chain/sprocket
end cover
Chain tensioner
ring
Fig. 13
Telescoping pole
Assembly lock
Chain saw head
R
Fig. 14
Lock tab
Assembly lock
Loading ...
Loading ...
Loading ...