Ancona AN1293R User Manual

Loading ...

— 13 —

STEP 11

Venting (exterior)

• Depending on exterior ventilation chosen (see page 10), either exit the ducting through the ceiling or wall.

• Alwaysuserigidtypemetal/aluminumducttube(followthebuildingcodesinyourarea)tomaximizeairow.Makesure

thatthebackdraftapscanopen,toallowmaximumairow.Connecttheducttubetothevent/damperandsecurely

seal with certied aluminum or foil tape so that it is air tight. Please check the building codes in your city to learn which

tape product is recommended.

IMPORTANT:

• Observeallgoverningcodesandordinances.

• It is the customer’s responsibility to contact a qualified electrical installer.

• Ifcodespermitandaseparategroundwireisused,itisrecommendedthata

qualified electrician determine that the ground path is adequate. A 120-Volt, 60

Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-ampcircuit,

fused on both sides of the line.

• DONOTgroundtoagaspipe.

• Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.

• DONOThaveafuseintheneutralorgroundcircuit.

IMPORTANT: Save this Installation Guide for electrical inspector’s use.

GROUNDING INSTRUCTIONS:

• Thisappliancemustbegrounded.Intheeventofanelectricalshort-circuit,groundingreducestheriskofelectric

shock by providing an escape wire for the electric current.

WARNING: Improper grounding can result in a risk of electric shock.

• Consultaqualifiedelectricianifthegroundinginstructionsarenotcompletelyunderstood,orifdoubtexistsasto

whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,

have a qualified electrician install an outlet near the appliance.

• Therangehoodmustbeconnectedwithcopperwire/plugonly.Therangehoodshouldbeconnecteddirectlyto

the fused disconnect (or circuit breaker) box through flexible armored or non-metallic sheathed copper cable. UL/

CSA listed strain relief must be provided at each end of the power supply cable. Use only with range hood cord-

connection kits that have been investigated and found acceptable for use with this model.

Installation

Fig #9

• Secure all the leads inside the wiring compartment.

• Secure the wiring compartment with a screw.

• WARNING: ALL CONNECTORS MUST BE ENCLOSED IN THE WIRING

COMPARTMENT. (See Fig #9)

SAFETY WARNING: Risk of electrical shock. This range hood must be

properly grounded. Make sure this is done by a qualied electrician

in accordance with all applicable national and local electrical codes. Before

connecting wires, switch power off at service panel and lock service panel

to prevent power from being switched on accidentally.

Loading ...

Ancona AN1293R 30 Inch White Non Ducted Standard Hood Under Cabinet Hood