Loading ...
Loading ...
Loading ...
— 12 —
STEP 8
Attaching Vent/Damper
• When installing with internal recirculation function,
unscrew the three screws from top plate of range hood.
(See Fig #3)
• Remove the steel panel from top of the range hood and
replace with venting plate. (See Fig #4)
Installation
STEP 10
Electrical Connection
• Open the wiring compartment with a Phillips screwdriver
• Please use the bushing provided on the cut-out opening to protect the
electrical wires.
• Connect cable to range hood wiring. (See Fig #8)
• Connect BLACK to BLACK, WHITE to WHITE and GREEN to GREEN.
• DON’T FORGET TO CONNECT THE GROUND! (green wire)
STEP 9
Installing the Hood
• Using measurements provided on Page 7, measure and drill 4 holes into bottom
of cabinet. (See Fig #7)
• If venting internally, use measurements provided on Page 7 and clearance on
Fig #1.
• If venting externally, depending on exterior venting chosen (See page 10), use
measurements provided on Page 7 and cut vent hole in cabinet.
• Align range hood to the holes in the bottom of the cabinet and screw in. (See
Fig #7)
Fig #7
Note: Use threaded drywall anchors only when mounting the hood
on sheet rock. Mounting the hood on wall studs or lumbers is highly
recommended.
Fig #3 Fig #4
Fig #8
• If choosing exterior venting option, depending on the
exterior venting option chosen (See page 10), pop out
the steel panel on either the top or rear of the range
hood. (See Fig #5)
• Using the supplied screws, attach the rectangular vent/
damper to the rear of the range hood. (See Fig #6)
Fig #5 Fig #6
Loading ...
Loading ...
Loading ...