Loading ...
Loading ...
Loading ...
NSTALLAT ON NSTRUCT ONS
5, Partially install the 2, #12 x %" hex head sheet metal screws
in the lower holes. Leave a space of about 3A"(1 cm) between
i the screw head and the bottom of the washer or dryer.
Follow these instructions to install the pedestal on a washer or dryer.
A B
1, Open pedestal drawer and remove the envelope inside. This
envelope contains 4, #12 x 5/8"hex head sheet metal screws
used in step 5.
2, Verify the 4 spacer pads are installed on the top of the
pedestal.
3,
A. Spacer pads
Using a 1/4"nut driver, remove the hex-head screws from both
drawer slides and save screws. Remove the drawer from the
slides and set aside. Push the slides back into the pedestal
_j X_ _
C C
A. Washer bottom
B. Dryer bottom
C. Install screws
6, Tip the pedestal on its back and move it against the washer
or dryer bottom, Slide the pedestal's keyhole slots over the
lower 2 partially installed screws,
7, Position the pedestal toward the front of the washer or dryer
and install the 2 remaining hex-head sheet metal screws, Do
not tighten completely,
8, Align the sides of the pedestal so that they are even with the
sides of the washer or dryer, Reach inside the pedestal
drawer opening and securely tighten all 4 pedestal screws,
%
HHHHHHHHHH_
4,
Ifyour washer or dryer has feet installed, remove them, Do
not install the feet that came with a new washer or dryer,
A. Lower screws in keyhole slots
9, Tip the washer or dryer back to its upright position, Remove
and discard packaging including washer's plastic film, corner
posts and top cap,
10 Slide the washer or dryer close to its final location,
11, Follow the Installation Instructions that came with your model
to finish installing or reinstalling your washer or dryer (hoses,
vents, etc,),
Loading ...
Loading ...
Loading ...