Loading ...
Loading ...
Loading ...
Connect
the Tubing to
Water Line
1. Unplug refrigerator or disconnect power.
2. Turn off the main water supply. Turn on the nearest faucet to relieve the
pressure on the line. It may help to open anoutside faucet to allow the water to
drain from the line in the house.
3. Find a 1/2dnch to 1-1/4-inch vertical COLD water pipe near the refrigerator.
4. To determine the length of copper tubing you will need, measure from the
connection on the lower left rear of the refrigerator to the water pipe. Add 7
feet (2.1m) to allow for moving refrigerator for cleaning. Use 1/4dnch O.D.
(outside diameter) copper tubing. Be sure both ends of copper tubing are cut
square.
5. Using a drill, drill a 1/4dnch hole in the cold water pipe you have selected.
6. Fasten the shut-off valve to cold water a pipe with pipe clamp. Be sure outlet
end is securely in the 1/4dnch drilled hole and the washer is under the pipe
clamp. Tighten the packing nut. Tighten the pipe clamp screws carefully and
evenly so the washer makes a watertight seal. Do not overtighten or you may
crush the copper tubing, especially if sort (coiled) copper tubing is used. Now
you are ready to connect the copper tubing.
7. Slip the compression sleeve and compression nut onto the copper tubing as
shown. Insert end of the tubing into outlet end squarely as far as it will go.
Screw compression nut onto the outlet end with an adjustable wrench. Do not
over tighten.
8. Place the free end of the tubing into a container or sink, and turn ON main
water supply. Flush out tubing until water is clear. Turn OFF the shutoff valve
on the water pipe. Coil the copper tubing as shown below.
_ Cold Water Pipe
Packing Nut\ _/JJ Pipe Clamp
Shut Off Valve \ A_-- _'_I Coil of Polyethylene or
Compres_
Loading ...
Loading ...
Loading ...