RL94IP Operation Manual

Loading ...

VC Series Manual 35

Temperatures Available with a Controller

The water heater can deliver water at only one temperature seng at a me. The available temperatures are

provided below. A temperature lower than 98° F (37° C) can be obtained at the tap by mixing with cold water.

To change the temperature scale from Celsius to Fahrenheit or vice versa, press and hold the “On/O” buon

for 5 seconds while the water heater is OFF.

These temperatures are suggesons only:

* Temperature sengs from 125-140 °F (52-60 °C) are available by seng switch 6 to ON in the SW1 Dip

switch (tan switches). These models have a default maximum temperature of 120° F (49° C) and an opon

(switch 6) to increase the maximum temperature to 140 °F (60 °C).

DO NOT adjust the other switches unless specically instructed to do so.

WARNING

• Kitchen 120 °F (49° C)

• Shower 98 - 110 °F (37 - 43 °C)

• Bath Fill 102 - 110 °F (39 - 43 °C)

Temperature Sengs Available (Fahrenheit °F)

RL75i, RL75e

98 100 102 104 106 108 110 115 120

125

130

135

140

150

160

RL94i, RLX94i,

RL94e

185**

Celsius °C 37 38 39 40 41 42 43 46 49 52 54 57 60 66 71 85

** These sengs require the MCC-91-2 controller. When the MCC-91-2 controller is connected, these higher

temperatures are available on all controller models in the system. Use of an MCC-91-2 controller in a

residenal dwelling will reduce the warranty coverage to that of a commercial warranty applicaon.

Alternate Temperature Sengs

A dierent range of temperature sengs is available by seng switches 2 and 3 of the SW2 dip switch (white

switches) to ON. The table below shows the sengs available with the MC-91-2 and MCC-91-2 controller.

Alternate Temperature Sengs Available (Fahrenheit °F)

RL75i, RL75e

110 115 120 125 130 135 140 145 150 155 160

RL94i, RLX94i, RL94e

165 170 175 180 185

Celsius °C 43 46 49 52 54 57 60 63 66 68 71 74 77 79 82 85

MC-91-2

MCC-91-2

MC‐91‐1, MCC‐91‐1, MC‐100V‐1, and BC‐100V‐1 controllers are not compable with

Alternate Temperature Sengs. Alternate Temperature Sengs are for commercial

applicaons only.

DO NOT use the MC‐91‐1, MCC‐91‐1, MC‐100V‐1, or BC‐100V‐1 controllers when dip

switches 2 and 3 (white switches) are in the ON posion.

WARNING

Loading ...

Operation Manual - Page 35