Loading ...
Loading ...
Loading ...
7WWW.SENIXTOOLS.COM
ASSEMBLY/ADJUSTMENT
SAW CHAIN LUBRICATION
The pole saw features automatic chain lubrication. Never
operate the pole saw without saw chain oil. The use of the
pole saw without enough saw chain oil will damage
the unit.
Only use special saw chain oil. Other oils will run the risk
of damaging the unit and voiding the warranty.
Take note of temperature conditions. Using the saw at
various temperatures requires the use of diering oils. To
ensure a sucient layer of lubricant at lower temperatures,
use liquid oil (low viscosity).
FILLING THE OIL TANK
1. Place the saw on a level surface. Clean the area around
the oil tank cap and then open it.
CAUTION: Make sure that no dirt gets into the oil tank
to prevent clogging in the oil nozzle.
2. Fill the oil tank with 3.4 oz. of saw chain oil (Figure 3).
1
Figure 4 - Oil tank
3. Close the oil tank cap.
ATTACH /REMOVE THE BATTERY
CAUTION: Only use a Senix-approved battery
and charger.
Note: The battery is not fully charged at the time of
purchase. Charge it fully before using it for the
rst time.
To insert the battery, slide it into the back of the unit until a
“click” is heard. Make sure the battery is fully inserted and
latched into position.
To remove the battery, press the release button and slide
the battery out.
WARNING — Do not insert or remove the battery while
the trigger is pressed or while the chain
is in motion.
!
!
!
Loading ...
Loading ...
Loading ...