Loading ...
Loading ...
Loading ...
EN
9
Installation
3
Preparation
4
Connecting the water hose to the refrigerator
• Connect the water line to a water supply valve.
If a valve is not present or you are not sure, consult
a qualified plumber.
Connecting the water line to the water supply
1. Slip the union (B) on to the water hose (A)
2. Push the water hose downwards firmly to slip it onto the
water inlet valve (C).
3.Tighten the union (C) by hand to ecure it onto the water
inlet valve.Normally, you are not required to tighten the
union with a tool.However, you can use a wrench or pliers
to tighten the union if there is a leakage.
WARNING: Connect to potable
water supply only.
WARNING: Fill With Potable
Water Only.
Before you start the refrigerator, Check the
following before you start to use your refrigerator:
1. Clean the interior of the refrigerator as
recommended in the “Maintenance and cleaning”
section.
2. Connect the plug of the refrigerator to the wall
socket. When the fridge door is opened, fridge internal
lamp will turn on.
3. When the compressor starts to operate, a sound will
be heard. The liquid and gases sealed within the
refrigeration system may also give rise to noise, even if
the compressor is not running and this is quite normal.
4. Front edges of the refrigerator may feel warm. This is
normal. These areas are designed to be warm to avoid
condensation.
4.1 Placing and Installation
If the entrance door of the room where the
refrigerator will be installed is not wide enough for
the refrigerator to pass through, then carefully
remove the doors of your refrigerator and pass it
sideways through the door.
Loading ...
Loading ...
Loading ...