Loading ...
Loading ...
Loading ...
LIFTER
5/32 IN. SETSCREW
WRENCH _'_
7. Using a 1/8" Hex "t.'.'wrench, remove the six lifter
screws, (Two under each blade.)
8, Clean cutterhead, wedges and screws thoroughly
with Craftsman Gum and Pitch Remover. Also re-
move the oil from new blades.
9. Replace the six lifter screws and screw them in all
the way, but do not tighten,
10. Insert a knife in one of the slots,., so it projects
1/t6 of an inch beyond each end of the cutterhead.
Note that the face with the cutting edge is against
the wedge as shown,
11. Insert a wedge next to knife so the flat side of the
wedge is against the knife. Push wedge in manu-
ally-do not install two locking setscrews at this
time.
i ¸ •
12. Adjust cutter knives as follows:: :
a. Put a piece of notebook paper on top of the
outfeed table. :_ ....... __
b. Put the head of a squareon topof the paper.
The end of the square must extend past the end
of the outfeed table and above one end of the
cutterhead; i , i....
c, Turn the lifter screws counterclockwise to raise
the knife until if just touches the square.
d, _To check your adjustrnenti I;gently turn the cut-
terhead back and forth by moving the cutterhead
pulley, The knife should just touch the square
without raisinglthe square off the paper. This
same adjustment must be made at the other
end of the cutterhead.
e. tfthe adjustment:is done correctly, the knives
will nowbe slightly above the ouffeed table by
approximately :003 of an inch (the thickness of
an, average piece of paper),
.... NOTE: This adjustment can be made more ac-
curately by:using a knife setting gauge (Cat,
#9-2647) available at Sears.
• _i<_:ii_!!_, _ :i,i, _!,i_i,_i,_i/_ ii ii_i !_
NOTEBOOK PAPER
OUTFEED
TABLE
33
Loading ...
Loading ...
Loading ...