Loading ...
Loading ...
Loading ...
5. FENCE TILT SCALE.
Indicates the ang!e of the fence to the tables: When
the 900 fence stol_ s correct y adjusted; the fence
will be90Q to the table and the scale wil! read 90°_ FENCE
To Check for squareness, place an accurate square
on infeed table and check fence while_locked at 90°
position, MAKE SURE 90° STOP IS AGAINST
SLIDE BRACKET.
tf fence is not square to table:
a. Slightly loosen fence lock knob and guard lock
knob.
b. Loosen 90° stop screw with small screwdriver
and turn knurled sleeve which will cause fence
to tilt. Turn sleeve in either direction until fence
is square with infeed table.
NOTE: If you cannot square fence by turning
knurted sleeve, loosen three screws "A" and ad-
just fence square to table.
c. Tighten 90° stop iockscrew and both fence lock
knobs.
CUTTER
GUARD
dr
If 90 ° reading on tilt scale does not line up with
top surface of the slide bracket, loosen screws
holding scale and move it... tighten screws,
A
KNURLED
SLEEVE
45°STOP
KNURLED
SLEEVE
90°STOP
45 ° STOP
90 ° STOP
FENCELOCK,_ _"
KNOB
SLIDE
BRACKET
e. Adjust 45° stop in the same manner.
NOTE: Tilt scale
adjusted for 90 °
SQUARE
\
FENCE
FACE
will n_ _require adju_ment if it was
0osition.
HEAD
OF
JSQUARE
tNFEED
TABLE
SCALE
ADJUSTING
SCREW
45=STOP
LOCKSCREW
TILT
90 _ STOP
SCALE
ADJUSTING
SCREW
INFEED
TABLE
v ,,, •
CUTTERGUARD
23
Loading ...
Loading ...
Loading ...