Loading ...
Loading ...
Loading ...
Avoid Service
Checklist
Before calling for service, review this list. I1may save both time and expense. The list includes
common occurrences that are not the result of defective workmanship or materials in this dryer.
OCCURRENCE POSSIBLE CAUSE SOLUTION
Emyer aces not star< Electrical power cord is not securely plugged Make sure the plug fits tightly inwall outlet
in or plug may be loose
House fuse blown or circuit breaker tripped Reset circuit breaker or replace fuse,
Make sure electrical line is net overloaded and the dryer is
on a separate circuit,
Thermal limiter tripped Call authorized service person for replacement
Dzyer _s bum wcn't heat. Thereare2housefusesinthedryerdrcuitlf Re@acefuse,
1of the 2 fuses isblown, the drum may turn
but the heater will net operate
Gas sup@y valve is not open (gas models) Checkto make suresup@yvalve isopen, SeeINSTALLATION
INSTRUCTIONSfor procedure,
Dryer does net have enough air sup@y to See INSTALLATION INSTRUCTIONS
support the burner flame (gas models),
LPgassup@ytankisempty or there has been Refill or replace tank,
a utility interruption of natural gas (gas
models), Dryer should heat when utility service is restored,
£L_y£ncsr Cycle takes tco lcngr , Lint screen isclogged with lint Make sure all lint has been removed flom the dryer lint
ctltside of the cLryer feels screen before starting each cycle,
too hDt or _lls hDt.
Exhaust duct requirements have net been Exhaust duct must be at least 4 inches indiameter and made
met, of rigid or flexible metal
When in place, the duct must have no more than two 90°
bends and must not exceed length listed in INSTALLATION
INSTRUCTIONS,
Electricdryeriscennectedtoa208vekcircuit, Drying time will be 20% longer than drying on a 240 volt
circuit
Drying procedures have net been followed See Dry£'sg kcc_i_r-es, page 4,
Outside exhaust hood or exhaust duct may Clean out any obstruction
be clogged or restricted
High humidity Use a dehumidifier near the dryer,
Excessive wz_nkZing. Dryer is overloaded Do not overload See D<:z£'sgkoc_:Sures, page 4
Items left in dryer toe long, Remove items as soon as cycle ends
Insufficient sorting of items See Dzyi_2r i>z_c_o_zr'es,page 4
Drying temperature too high, Follow fabric care label instructions,
Foreign objects such as coins, pins, clips or Always remove foreign objects from pockets before
buttons are inside the dryer laundering Remove objects from drum and restart dryer,
Permanently attached items such as belt It may be necessary to baste a scrap of material securely
buckles, zippers and fasteners may be hitting around ornaments before drying to prevent scratching and
the inside of the drum, damage to the dryer
Drum damage caused by foreign objects or
permanentlyattached it_ is not covered by the
warranty.
Scratchingorchippingofthe
d:_ fL_ish.
Loading ...