Loading ...
Loading ...
Loading ...
Refer to the chart below
if
this unit does not function properly.
If
the problem you are experiencing
is
not listed below or
if
the instructions below do not help, tum
off
this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
Problem
Cause
Remedy
See
page
This
unit
fails
to
turn
The power cable
is
not connected to the AC
IN
Connect the power cable firmly.
on.
inlet on the rear panel
or
not plugged
in
the
AC
15
wall outlet.
The
disc
traydoes
not
A foreign object
is
obstructing the tray.
Carefully check the disc tray and remove the
-
close completely. foreign object.
Playback does
not
The disc
is
damaged. Check the disc carefully; replace
it
if
necessary. -
start.
There
is
moisture on the laser pickup. Wait 20 to 30 minutes after switching on the unit
-
ON before trying to play back a disc.
The disc
is
loaded upside down. Reload the disc with the label side
up.
-
The disc
is
dirty.
Clean the disc.
20
The MP3 or WMA formats are not compatible
Replace the disc with a correctly recorded disc
20
with this unit. playable with this unit.
The CD-RW (ReWritable) disc
is
not recorded Replace the disc with a correctly recorded disc
19
correctly.
playable with this unit.
The disc
is
a non-standard disc not playable with Replace the disc with a correctly recorded disc
19
this unit. playable with this unit.
Playback
is
delayed, The disc may be scratched or damaged. Check the disc carefully; replace
it
if
necessary.
or
begins
at
the
20
wrong
place.
No sound.
Improper output cable connections. Connect the cables properly.
If
the problem
14
persists, the cables may be defective.
Improper amplifier operation. Set the amplifier controls
to
the correct input
-
selection.
Sound
ofa
PURE DIRECT
is
turned on. Turn PURE DIRECT off.
Or
make an analog
6
component
connection.
connected
to
the
DIGITAL OUT jacks
is
Super Audio
CD
layer
is
playing. Switch the playback layer.
Or
make an analog
6,10
not
played.
connection.
Sound
"skips".
This unit
is
being subjected to vibrations or Relocate this unit.
impacts.
-
The disc
is
dirty. Clean the disc.
20
Sound
"hums".
Improper cable connections. Securely connect the audio cables.
If
the problem
14
persists, the cables may be defective.
Noise from a nearby The tuner
is
too close
to
this unit.
Move the tuner and this unit farther apart.
tuner.
-
Noise from Inside
of
The disc may be warped.
Replace the disc.
the
disc
tray.
-
I
21
En
Loading ...
Loading ...
Loading ...