Loading ...
Loading ...
Loading ...
-10-
Operating Instructions
Assembly
Disconnect battery pack
from tool before making
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the
tool accidentally.
INSERTING BITS
Move reverse switch lever to the center
“OFF” position. Rotate the chuck sleeve
counter-clockwise viewing from chuck end,
and open chuck to approximate drill bit
diameter. Insert a clean bit up to the drill
bit flutes for small bits, or as far as it will
go for large bits. Close chuck by rotating
the chuck sleeve clockwise and securely
tighten by hand (Fig. 2).
Do not use the power of
the drill while grasping
chuck to loosen or tighten bit. Friction
burn or hand injury is possible if
attempting to grasp the spinning chuck.
PROTECTION AGAINST DEEP
DISCHARGING
The lithium ion battery is protected against
deep discharging by the “Electronic Cell
Protection (ECP)”. When the battery is
empty, the tool is switched off by means of a
protective circuit.
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON"
or "OFF" by squeezing or releasing the
trigger. The speed can be adjusted from the
minimum to maximum nameplate RPM by the
pressure you apply to the trigger. Apply
more pressure to increase the speed and
release pressure to decrease speed (Fig. 1).
FORWARD/REVERSING
LEVER & TRIGGER LOCK
After tool use, lock trigger
in “OFF” position to help
prevent accidental starts and accidental
discharge.
Your tool is equipped with a
forward/reversing lever and trigger lock
located above the trigger (Fig. 3). This lever
was designed for changing rotation of the
bit, and for locking the trigger in an “OFF”
position.
For forward rotation, (with chuck pointed
away from you) move the lever to the far
left.
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to
the center off position.
Do not change direction of
rotation until the tool
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
CHUCK SLEEVE
FIG. 2
DRILL BIT
BIT HOLDER
SCREWDRIVER BIT
FIG. 3
!
CAUTION
2610056734 02-21 PS11_BM 2610022006 04-12.qxp 2/15/21 10:39 AM Page 10
Loading ...
Loading ...
Loading ...