Loading ...
Loading ...
Loading ...
ignitor Lighting
A Do not lean over grill while lighting.
1. Turn OFF gas burner control valves.
2. Turn ON gas at LP cylinder.
3. Open lid during lighting.
4. To ignite, turn left knob to the HIGH position.
5. Push IGNITOR button rapidly.
6. If ignition does NOT occur in 5 seconds, turn the burner
controls OFF, wait 5 minutes and repeat the lighting
procedure.
7. To ignite right burner, turn knob to the HiGH position.
If ignitor does not work, follow match lighting instructions.
After Lighting: Turn knobs to HIGH position for warm-up.
Turn controls and gas source or tank OFF when not
in use.
CAUTION
If burner does not light, turn knobs to OFF, wait 5
minutes, and try again. Always close valve during the 5
minute waiting period. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidentally ignite with risk of injury.
Match-Lighting
A Do not lean over grill while lighting.
1. Turn OFF gas burner control valves.
2. Turn ON gas at LP cylinder.
3. Open lld during lighting.
4. Place match into match holder (hanging from side of cart).
Strike the match.
5. Place lit match through the match light hole and near the
burner. Push in and turn left knob to the HIGH position.
Be sure the burner lights and stays lit.
6. Light right burner by pushing knob in and turning to the
HIGH position.
NOTE: Side shelf removed for clarity
Burner Flame Check
" Remove cooking grates and heat diffusers. Light burner,
rotate knobs from HiGH to LOW. You should see a smaller
flame in LOW position than seen on HIGH. Always check
flame prior to each use. If only low flame is seen refer to
"Sudden drop or low flame" in the Troubleshooting Section.
-- LOW
Hose Check
" Before each use, check to see if hoses are cut, worn or kinked.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified in the Parts List.
Turning Grill Off
" Turn all knobs to OFF position. Turn LP tank off by
turning OPD hand wheel clockwise to a full stop.
Ignitor Check
- Turn gas off at LP tank. Press and hold ignitor button. "Click"
should be heard and spark seen each time between collector
box or burner and electrodes. See "Troubleshooting" if no
click or spark.
Valve Check
" Important: Make sure gas is off at LP tank before checking
valves. Knobs lock in OFF position. To check valves, first
push in knobs and release, knobs should spring back. If knobs
do not spring back, replace valve assembly before using grill.
Turn knobs to LOW position then turn back to OFF position.
Valves should turn smoothly.
General Grill aeaning
" Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory (and should never be painted). Apply a strong
solution of detergent and water or use a grill cleaner with
scrub brush on insides of grill lid and bottom. Rinse and allow
to completely air dry. Do not apply a caustic griH/oven
cleaner to painted surfaces.
" Plastic parts: Wash with warm soapy water and wipe dry.
A Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic parts. Damage to and
failure of parts can result.
" Porcelaln surfaces: Because of glass-like composition, most
residue can be wiped away with baking soda/water solution
or specially formulated cleaner. Use nonabrasive scouring
powder for stubborn stains.
" Painted surfaces: Wash with mild detergent or nonabrasive
cleaner and warm soapy water. Wipe dry with a soft
nonabrasive cloth.
12 • 464622013
Loading ...
Loading ...
Loading ...