Loading ...
Loading ...
Loading ...
Installation instructions en
27
1.
Identify the phase and neutral conductors in the
socket.
The appliance may be damaged if it is not connec-
ted correctly.
2.
Only connect the appliance to a mains voltage
between 220 und 240V.
3.
Connect the wires of the mains power cable accord-
ing to the colour coding:
‒ Green/yellow = Conductor
‒ Blue = Neutral conductor
‒ Brown = Phase (external conductor)
Appliance connected loads
You can select a different connection depending on the appliance model. In this case, you must connect the appli-
ance on the rear of the appliance using the power cord in accordance with the connection diagram.
Ensure that the power cord corresponds to H05VV-F or higher. Determine which wire cross section you require in ac-
cordance with the current load. If required, install copper bridges. Incorrect connections may damage the appliance.
Appliance connected load Min. fuse protection at 1~ Min. fuse protection at 2/3N~
3.3kW 16A
4.2kW 20A 12A
20.8 Installing the appliance
1.
Slide the appliance and centre it.
Do not kink the connection cable.
2.
Open the oven door completely.
3.
Remove the cover.
4.
Screw the appliance tightly onto the unit.
5.
Put the protective cover on.
Note:Never close the gap between the worktop and
the appliance using additional battens.
20.9 Removing the appliance
1.
Disconnect the appliance from the power supply.
2.
Undo the fastening screws.
3.
Lift the appliance slightly and pull it out completely.
Loading ...