Loading ...
Loading ...
Loading ...
9Cyclone Insert Installation - English
Preparation for Installation
1. Unpack range hood and check contents. Note: Be cautious of
sharp edges within the unit.
2. Cut the insert cutout at the bottom of the cabinet using the
given cutout measurements on page 13 (Figure 1).
3. Locate the cutout at the center of the bottom of the cabinet.
Ensure that the front panel of the range hood is ush with the
surface of the cabinet doors.
SS130 INSERT HOOD INSTALLATION
is appliance requires 120V 60Hz electrical supply and
connection to an individual properly grounded branch circuit
protected by a circuit breaker or time delay fuse.
• Turn o power circuit at the service panel before wiring
this unit.
• All electrical work must be done by a qualied electrician
in accordance with all applicable codes and standards.
is range hood must be properly grounded.
WARNING
• At least two installers are required due to the weight and
size of the hood.
CAUTION
Figure 1.
1. Remove outer mesh lters of range hood
2. Attach rubber seal and damper to rectangular cutout on top
of the range hood using the screws provided.
3. Hold range hood upright, mesh lters facing down and
insert range hood upward into cabinet cutout. e range
hood mounts to the cabinetry by two spring loaded brackets,
one on each side of the range hood (Figure 2).
4. Once the range hood is through the cabinetry the brackets
should release. e brackets loosely hold the range hood in
place (Figure 3).
5. Pull the slide outwards to expose the inside of the range
hood. Locate the adjustable screw hole underneath both
sides of the hood.
6. Once located, use a Phillips screwdriver to tighten the
adjustable screw until the unit is tightly fastened to the
base of the cabinetry (Figure 4). (NOTE: A piece of 1/4”
thickness strip may be needed to put underneath the brackets
to tighten the screws. Four 3/4” screws can be used to mount
the hood fan to the cabinet through the holes at the bottom
of the unit for SS130 30”)
7. Make sure that the adapter is connected to ductwork.
8. Place mesh lters back into place.
9. Connect the power plug to the junction box.
Install the SS130 Range Hood
Figure 3.
Figure 2.
Fasten Screws
Figure 4.
Loading ...
Loading ...
Loading ...