Loading ...
Loading ...
Loading ...
Removing and Replacing the Warming Drawer (Stainless Steel models only)
Pull upwith tlnL_
R_move shield on rizl
E41de. Pull up onleft le_er
whilepushingdown o_
Pushdownwith finger
Figure 1
Figure 2
To Remove Warming Drawer:
1. _ Turn power off before removing the Warming Drawer.
2. Open the drawer to the fully opened position.
3. On the right glide you will find a shield attached with a hex-head screw
(See Figure 1). Using a 1/4" socket and ratchet remove the shield.
4. Locate glide lever on each side of drawer, pull up on the left glide lever
and push down on the right glide lever.
5. Pull the drawer away from the range.
To Replace Warming Drawer:
1. Replace shield on the right glide of the drawer body.
2. Pull the bearing glides to the front of the chassis glide (See Figure 2).
3. Align the glide on each side of the drawer with the glide slots on the
range.
4. Push the drawer into the range until levers "click" (approximately 2").
Pull the drawer open again to seat bearing glides into position. If you do
not hear the levers "click" or the bearing glides do not feel seated
remove the drawer and repeat steps 2-4. This wilt minimize possible
damage to the bearing glides. Using a 1/4" socket and ratchet replace
the shield.
NOTE: The Warming Drawer will NOT operate while in the "Self-Clean" and
"Oven Lockout" modes.
'_ _ Electrical Shock Hazard can occur and result
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the Warming Drawer.
Operating and Replacing the
Oven Light
Holder
Figure 3
Be sure the range is unplugged and all parts are COOL
before replacing the oven light. Wear a leather-faced glove for protection
against possible broken glass.
To operate the Oven Light:
The interior oven light will automatically turn on when the oven door is
opened. Press _ to turn the light ON and OFF when the oven door is
closed. The oven light is located at the rear walt of the oven interior and is
covered with a glass shield held by a wire holder (See Fig. 3). The oven
light glass shield must be in place whenever the oven is in use.
To Replace the Oven Light:
1. Turn electrical power off at the main source and unplug the range.
2. Press Wire Holder to one side to release the glass shield.
3. Replace the old bulb with a new 40 watt appliance bulb.
4. Replace Glass Shield over bulb and snap Wire Holder into place.
5. Turn power back on again at the main source (or plug in the range).
6. The clock will then need to be reset. To reset, see Setting the Clock
in this Use & Care Manual.
34
Loading ...
Loading ...
Loading ...