Loading ...
Loading ...
Loading ...
Lift and stabilize the front of the deck.
• Loosen the center hex bolt and lower the blade and engine pulley until there is adequate clearance to move
the belt past the belt keeper.
Remove the belt from the engine pulley and around the blade. See Figure 21.
Reassemble in reverse order with new belt (part # 754-0465), NOTE: Begin idler reassembly by inserting bolt
up through the idler bracket hole. Adjust the drive clutch following instructions on page 16 of this manual.
IMPORTANT: Torque center hex bolt to between 450 and 600 in. Ibs.
Right Front _--_I - - -_'_-_- __1 Left Front
Wheel \_H i(__l _::::::::_; :_ i._ "fj Wheel
/_'--_(/ _ _ '_ Remove belt
Engine /from around
Pulley "'_ _\ rt___ /pulley and blade
Center _ _'_ _ "/
Hex Bolt _ _J'_ 1
J
Figure 21
Maintaining Engine
Refer to the separate engine manual for engine maintenance instructions.
Maintain engine oil as instructed in the separate engine manual oacked with your unit. Read and follow
instructions carefully,
Service air cleaner every 25 hours under normal conditions. Clean every few hours under extremely dusty
conditions. Poor engine performance and flooding usually indicates that the air cleaner should be serviced
To service the air cleaner, refer to the separate engine manual packed with your unit.
The spark plug should be cleaned and the gap reset once a season. Spark plug replacement is
recommended at the start of each mowing season: check engine manual for correct plug type and gap
specifications.
• Clean the engine regularly with a cloth or brush. Keep the cooling system (blower housing area) clean to
permit proper air circulation which is essential to engine performance and life. Be certain to remove all grass,
dirt and combustible debris from muffler area.
SECTION 13: OFF-SEASON STORAGE
The following steps should be taken to prepare lawn mower for storage if it will not be used for 30 days or more.
Compliance with these instructionswill ensure that your mower willwork properly when itis reused next season.
• Clean and lubricate mower thoroughly as described in the lubrication instructions.
• Refer to engine manual for correct engine storage instructions.
• Coat mower's cutting blade with chassis grease to prevent rusting.
•Store mower in adry, clean area. Do not store next to corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment in a poorlyventilated or metal storage shed, care should be taken
to rust-proof the equipment. Using a light oil or silicone, coatthe equipment, especially cable and all moving parts.
21
Loading ...
Loading ...
Loading ...