Loading ...
Loading ...
Loading ...
BISSELL.com 7
Cleaning Your Floors
For cleaning tips for stuck-on messes and more, visit support.BISSELL.com.
Note: Before cleaning area rugs, check the manufacturer’s tag and test an inconspicuous spot on the
rug for colorfastness. Don’t use on silk or delicate rugs.
1. Plug machine into a properly
grounded outlet. Press power
button to turn machine ON and
OFF. When powered ON, starts
in SteamWash mode.
2. Press mode button to
switch between modes. See
page 6 for cleaning mode
information. Mode selection
appears on foot display. If you
chose SteamWash™, wait 30
seconds for it to warm up.
The steam ready light will
illuminate.
3. Recline machine to start
brush roll spinning. When
machine is standing upright,
brush roll will not spin.
Note: When returning to the
upright position, continue to
push machine forward after
the click until machine is
secured.
4. Before each use, hold
solution spray trigger for 10
seconds to wet the brush roll.
Note: Bubbles will appear in
brush roll window when solution
is flowing. Water on floor during
steam cleaning is normal.
5. Hold trigger to dispense
formula for all cleaning modes
and to dispense formula plus
steam in SteamWash mode.
Make forward and backward
passes to clean your floors.
6. To dry floor, release trigger
to stop dispensing solution
and steam. Make forward and
backward passes to suction up
excess water.
Please read the Hard Floor Sanitize formula label prior to each use. Use on hard nonporous floors only.
1. Follow cleaning instructions
above to remove visible soils.
To sanitize: Hold trigger to
apply solution to floor.
2. Allow floor to remain
visibly wet with formula for
five minutes. This may require
additional passes.
3. With trigger released, make
forward and backward passes
to extract solution.
Sanitizing Hard Floors
Loading ...
Loading ...
Loading ...