Loading ...
Loading ...
Loading ...
Become familiar with these terms before operating the
unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of
measure of air delivery.
PSIG: Pounds per square inch gauge; a unit of meas-
ure of pressure.
Code Certification: Products that bear one or more
of the following marks: UL, CUL, ETL, CETL, have
been evaluated by OSHA certified independent safety
laboratories and meet the applicable Underwriters
Laboratories Standards for Safety.
Cut-In Pressure: While the motor is off, air tank
pressure drops as you continue to use your accesso-
ry. When the tank pressure drops to a certain low
level the motor will restart automatically. The low
pressure at which the motor automatically restarts is
called "cut-in" pressure.
Cut-Out Pressure: When an air compressor is
turned on and begins to run, air pressure in the air
tank begins to build. It builds to a certain high pres-
sure before the motor automatically shuts off - pro-
tecting your air tank from pressure higher than its
capacity. The high pressure at which the motor shuts
off is called "cut-out" pressure.
Branch Circuit: Circuit carrying electricity from elec-
trical panel to outlet.
This unit is capable of powering the following Accessories. The accessories are available through the current
Power and Hand Tool Catalog or full-line Sears stores.
Accessories
• In Line Filter
• Tire Air Chuck
• Quick Connector Sets
(various sizes)
• Air Pressure Regulators
• Oil Fog Lubricators
• Air Hose:
1/4", 5/16" OR 3/8" I.D.
in various lengths
Specialty Tools Socket Driving
• Air Brush • 3/8" Impact/Butterfly Wrench
• inflating/Blow Gun • 3/8" Ratchet
• Grease Gun • 1/4" Ratchet
• Caulk Gun Material Shaping
• Engine Cleaner
• 2.625" Hammer
Carpentry Tools
• 1.625" Hammer
• Finishing Nailer / Stapler • Reciprocating Saw
• Construction Nailer / Stapler • Nibbler
Spray Painting
• Multi-Purpose Spray Gun
• Automotive Spray Gun
Contents of Carton
1 - Air Compressor
4 - Rubber Feet
3. Attach the four rubber feet to the unit's legs using
the four screws removed in step 2.
NOTE: Flat side of rubber feet goes against unit legs.
Tools Required for Assembly
1 - 3/8" socket or nut driver
Assemble Rubber Feet
1. Carefully place unit on side opposite of controls.
2. Using a 3/8 inch socket or nut driver remove the
screws attaching the unit to the shipping pallet.
NOTE: These screws will be used to install the rub-
ber feet.
_ Rubber Foot
_- Screw
7- ENG D23343
Loading ...
Loading ...
Loading ...