Loading ...
Loading ...
Loading ...
LED Lights -
Used to indicate failure cause.
Voltage Adjustment Knob -
Set knob to match correct unit voltage.
Fault Interrogation Knob - Never Adjusted.
Factory set to 8 seconds for the time it takes
for non-critical fault to be analyzed & before
de-energizing load.
Lock-out Time Delay Knob - Never Adjusted.
Used for time between de-energizing and
re-energizing the load with a factory setting
of 1 minute.
Line Side -
Incoming voltage from the contractor.
Load Side -
Outgoing voltage from the contractor
b.
a.
c.
d.
e.
f.
% Voltage Unbalanced Knob -
This is the allowable voltage unbalanced
between the 3 phases with a factory
setting of 10%.
Reset Switches -
Position 1: Full Manual Reset (MAN-MAN).
Manual control reset used for highly critical
loads. The system will not reset until the fault
is corrected and then manually reset by
personnel.
Position 2: Leave In Full Automatic Reset
(AUTO-AUTO). Auto Front/Manual Back
Reset (AUTO-MAN). Automatic reset is used
on the front line side only (Power coming into
the unit). Back load side requires manual
reset. This setting is typically used with a
reliable power source (Power to condenser
& evaporator motors, and compressor).
g.
h.
b.
a.
c.
d.
e.
f.
g.
h.
Page 18
The KwiKool Phase Monitor is factory installed and is located
inside the Control Box. The Phase Monitor can be accessed
through the right side service door as you face the unit and
removing the cover to the control box.
Loading ...
Loading ...
Loading ...