Loading ...
Loading ...
Loading ...
8
8.0 Installation
8.1 Unpacking the Machine
Do not handle the packed
machine using slings.
To install the machine, first remove the packing,
paying particular attention not to cut any electric
wires or hydraulic hoses. Lift using straps
(Figure 3).
Figure 3
8.2 Anchoring and Handling the
Machine
The base of the machine must be anchored to
the floor by two lag bolts or studs properly
anchored into concrete.
9.0 Electrical Connections
All electrical connections
must be done by a qualified
electrician. All adjustments or repairs must
be done with the machine disconnected from
the power source, unplugged. Failure to
comply may result in serious injury!
J-CK350-2 is rated at 220V.
J-CK350-4 is rated at 440V.
These machines are not supplied with a plug.
Use a plug and outlet rated at least 20 amps.
The circuit for the machine should also be
protected by at least a 20 amp circuit breaker or
fuse.
Make sure that the blade turns in the correct
direction. If it does not, simply reverse two of
the phase wires on the supply input.
The cold saw is now ready for use.
10.0 Controls
10.1 Control Panel
The Control Panel (Figure 4) is located on the
front of the cabinet stand and consists of the
Power and High/Stop/Low switches, described
below.
Power Switch – The Power switch has two
positions, Off and On.
High/Stop/Low Switch – This switch controls
the blade speed. To operate the saw, the power
switch must set to on, High or Low must be
selected, and the Run Trigger depressed.
Figure 4
10.2 Trigger Handle
To operate, the Power switch must be set to on
a Hi or Low speed selection made, and the
trigger handle depressed.
Figure 5
Loading ...
Loading ...
Loading ...