Loading ...
Loading ...
Loading ...
17
6. Install new brush (or reinstall current brush) and
gently press it all the way into hole until brass
clip is secured.
7. Install cap.
8. Repeat for other brush.
9. Reinstall motor sleeve and screws.
NOTE: It is recommended that saw be run without
load for several minutes to seat new brushes.
Figure 9-1
9.3 Lubrication
Ball bearings on blade guide assemblies and blade
wheels are permanently lubricated and sealed, and
require no further lubrication.
Periodically lubricate the vise leadscrew as needed
with #2 tube grease.
9.4 Additional servicing
Any additional servicing on the band saw should be
performed by an authorized service representative.
Loading ...
Loading ...
Loading ...