Ancona AN-2210 User Manual & Installation Instructions

Loading ...

— 38 —

Before Calling for Service

OVEN TEMPERATURE TOO HIGH OR

TOO LOW

• Wastheovenpreheated?

Push in and rotate the Temperature knob to the desired

setting and let the oven preheat until it reaches the

temperature before you begin cooking.

• Aretherackspositionedproperly?

See pages 31 to 32 for rack positioning.

• Isthereproperaircirculationaroundbakeware?

If bakeware takes up too much room, air circulation will

be reduced.

• Isthebatterevenlydistributedinthepan?

Check that batter is level in the pan when baking.

• Istheproperlengthoftimebeingused?

Make sure proper cooking time was used.

• Hastheovendoorbeenopenedwhilecooking?

 Oven“peeking”releasesovenheatandcanresultin

longer cooking times.

• Arebakeditemstoobrownonthebottom?

Move rack to higher position in the oven.

• Arepiecrustedgesbrowningearly?

 Usealuminumfoiltocovertheedgeofthecrustand/or

reduce baking temperature.

NO SPARK WHEN LIGHTING BURNER

• Electricalsupply-Theelectricalwiresortheplug

are not connected properly.

Connect with electrical power again. If the problem

continues, contact a qualied technician.

• Burner-Theburnerisnotinstalledcorrectly.

 Installtheburneragain.See“BurnerRingsandCaps

Replacement” section.

• Sparkpin-Ignitionelectrodeandtheholearenot

inserted properly.

 Installtheburneragain.See“BurnerRingsandCaps

Replacement” section.

THE FLAME GOES OUT ONCE

RELEASING THE KNOB

• Safetyvalve-Knobnotpresseddownlongenough.

Press and turn the knob again and hold down three

to ve seconds after the burner has been lit. This is a

safety feature.

BURNER WON’T IGNITE OR BURNS

UNEVENLY

• Gasvalve-Thevalveisnotopen.

Make sure the valve is completely open.

• Gaspipe-Theremaybeairinthegaspipe.

 Igniterepeatedlyuntilamecatchestoreleasetheair

from the pipe.

• Burnercapissues.

The burner cap is not placed correctly; replace the

burner cap. Some holes in the lid are blocked; clean the

holes of the lid.

• Sparkpin-Thesparkpiniswetorcontaminatedby

the food.

Clean and dry the spark pin.

• Gasconnectingpipes-Thegasconnectingpipes

are blocked or pinched.

Contact a qualied technician. Adjust or change the

connecting pipes.

STRANGE SMELL

• Gasleak-Turnoffthegasandcontacta 

qualied technician.

• Thegassupplypipeisoldand/orbroken.Change 

the gas supply pipe.

Loading ...

Ancona AN-2210 Gourmet 24 in. Dual Fuel with Convection Oven Freestanding Range

User Manual & Installation Instructions - Page 38