Loading ...
Loading ...
Loading ...
18
Optional Accessories for JWBS-14DXPRO Band Saw
714101 JRF-
14N Rip Fence Assembly
Includes guide bars, rip fence assembly, fasteners, and mounting instructions with parts list.
708716 JMG-14 Miter Gauge Assembly
For straight and angle cutting. Includes guide bar, pivoting support body, and adjustable stops.
Troubleshooting
(JWBS-14DXPRO Band Saw)
PROBLEM POSSIBLE CAUSE SOLUTION
Saw stops or will not start 1. Saw unplugged 1. Check plug connections
2. Fuse blown or circuit breaker tripped 2. Replace fuse or reset
circuit breaker
3. Cord damaged 3. Replace cord
Does not make accurate 1. Stop not adjusted correctly 1. Check blade with
45 deg. or 90 deg. cuts square and adjust stop
2. Angle pointer not set accurately 2. Check blade with square
and adjust pointer
3. Miter gauge out of adjustment 3. Adjust miter gauge
Blade wanders during cut 1. Fence not aligned with blade 1. Check and adjust fence
2. Warped wood 2. Select another piece of
wood
3. Excessive feed rate 3. Reduce feed rate
4. Incorrect blade for cut 4. Change blade to correct
type
5. Blade tension not set properly 5. Set blade tension
according to blade size
6. Guides not set properly 6. Adjust guides
Saw makes unsatisfactory 1. Dull blade 1. Replace blade
cuts 2. Blade mounted wrong 2. Teeth should point down
3. Gum or pitch on blade 3. Remove blade and clean
4. Incorrect blade for cut 4. Change blade to correct
type
5. Gum or pitch on table 5. Clean table
Blade does not come up 1. Extension cord too light or too long 1. Replace with adequate size and to
speed length cord
2. Low shop voltage 2. Contact your local electric
company
Saw vibrates excessively 1. Base on uneven floor 1. Reposition on flat, level
surface
2. Bad Poly-V belt 2. Replace Poly-V belt
3. Motor mount is loose 3. Tighten motor mount
hardware
4. Loose hardware 4. Tighten hardware
Parts
Ordering Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-
274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and Serial Number of
your machine available when you call will allow us to serve you quickly and accurately.
Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from JET.
Some parts are shown for reference only, and may not be available individually.
Loading ...
Loading ...
Loading ...