Loading ...
2
1. REMOVE ROOM FRONT
Remove the room cabinet by pulling it out at the
bottom to release it (1); then lift it up to clear the rail
along the unit top (2).
3. CONCEAL POWER SUPPLY KIT
SUB-BASE AND CHASEWAY
1. Remove the rectangular knockout at the bottom of
the junction box. Remove the rectangular knockout
at the right end of the sub-base.
2. Power Supply kit is placed between the two halves
of the chaseway. Observe the orientation of the
chaseway.
3. Align the screw holes and secure the halves
together using two type A screws.
• Slide the upper end of chaseway with wiring
protruding into rectangular knockout opening in the
junction box.Be sure chaseway “ears” are on the
inside of the box.
• Drive one type A screw through the junction box
bottom into the chaseway “ear” hole.
• Insert lower end of chaseway into rectangular hole
in sub-base and slide to right into the rectangular
knockout making sure chaseway “ears” are inside
the sub-base.
• Route wire toward the center of the sub-base.
• Drive one type A screw through the sub-base slotted
hole into chaseway “ear” hole.
2. REMOVE JUNCTION BOX
COVER
Remove the junction box cover by removing the screw
holding it to the assembly.
Installation Instructions
FOR 230/208 VOLT ZONELINE POWER CORD CONNECTIONS ONLY
For GE Zoneline AZ45 & AZ65 Series Units
,QVWDOODWLRQ,QVWUXFWLRQ6SHFL¿FWR8QLWV(QGLQJLQ:RU+LJKHU
This kit must be used in conjunction with a GE junction
box kit and sub base with chaseway.
Junction Box Cover
Junction Box
Screw
Knockout
Sub-base
Knockout
Chaseway
Cover
Chaseway
Power
Supply Kit
Loading ...
Loading ...
Loading ...