Loading ...
Loading ...
Loading ...
39
Freeze damage prevention (continued)
3
Drain the pipe.
(1) Extend the wand.
Operate with the buttons on the back
side of the remote control.
1. Press [MENU].
2. Use
to select "CLEANING".
Press [ENTER].
3.
Use to select "WAND
CLEANING MODE ON/OFF".
Press [ENTER] to extend the wand.
Hold the wand in the extended
position until no more water comes
from around the wand.
Press [ENTER] again to retract the wand.
(Release the pressure from the
water supply pipe.)
(2) Unplug the power plug.
(3) Remove the cover and water fi lter
drain valve.
Cover
Water fi lter drain valve
(4) Drain the water from the water
supply hose.
Water supply hose
Horizontally
(5) After draining the water, install the
water fi lter drain valve and cover.
Insert the water fi lter drain valve and use a
fl at-head screwdriver to tighten it securely.
(6) Insert the power plug.
4
Check that the POWER LED
on the main display is lit up.
(Page 15)
5
Set the water and toilet seat
temperature to "High".
(Page 22)
(To maintain the temperature.)
When fi nished, close the toilet seat and toilet lid.
■
To use the Washlet again
The water needs to be resupplied. (See below)
Resupplying the Water (After draining)
1
Open the shutoff valve.
• Check that water is not leaking from a pipe or the main unit.
2
If the power is not turned ON
Insert the power plug.
3
Discharge water from the wand.
(1) Pressing down the right side of the toilet seat,
(2)
Press [REAR] on the remote control for about two minutes to discharge water from the wand.
(It takes about one minute before water comes out. Catch the water in a paper cup or other receptacle.)
■
If the remaining water has frozen and no water comes out
• Heat the inside of the bathroom, and warm the water supply hose and shutoff valve using a cloth soaked in warm water.
Reference
Loading ...
Loading ...
Loading ...