Loading ...
Loading ...
Loading ...
12
INSTALLATION INSTRUCTIONS
straight out from the outlet.
• Immediately discontinue use of a damaged supply cord. If the supply cord is damaged, it must
be replaced by a qualified service professional with an authorized service part from the manu-
facturer.
• When moving the refrigerator away from the wall, be careful not to roll over or damage the
power cord
PROHIBIT
• Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
For personal safety, this appliance must be properly grounded.
• Do not use an adapter.
• Do not use an extension cord.
• Failure to follow these instructions can result in death, fire, or electrical shock.
UNPACKING REFRIGERATOR
WARNING
• Explosion and Fire Hazard. Flammable refrigerant used. Handle with care when moving refrig-
erator to avoid either damaging the refrigerant tubing or increasing the risk of a leak. Failure to
do so can result in death, explosion or fire.
• When moving the refrigerator, never tilt it more than a 45° angle. This could damage the
compressor and the sealed system. If the refrigerator has been placed in a horizontal posi-
tion for any period of time, wait 6 to 8 hours before plugging in the refrigerator to allow the
refrigerant to settle.
Step1. Remove all packaging material. This includes the corrugated base and all adhesive
tape holding the refrigerator accessories inside and outside.
Step2. Inspect and remove any remains of packing, tape or printed materials before power
ing on the refrigerator.
Step3. It is advisable to clean the inside of the refrigerator with lukewarm water using a
neutral detergent, and then to dry it thoroughly prior to use.
PROPER AIR CIRCULATION
WARNING
4”
4”
2”
To ensure your refrigerator works at the maximum eciency it was
designed for, you should install it in a location where there is prop-
er air circulation, plumbing and electrical connections. Your refrig-
erator is not designed to operate in temperatures below 60°(16°)
or above 100°(37°). The refrigerator must be placed on a hard,
flat ground; if cushioning is needed, stable, hard, nonflammable
cushion blocks shall be used, rather than the foam backing of re-
frigerator. The refrigerator shall be kept away from damp locations
where water is easy to splash; water or dirt shall be removed with
soft cloth timely to prevent rusting which may have an eect on the
electrical characteristics.
Place the refrigerator in a well-ventilated place, reserve a certain
space around and behind the refrigerator, and do not cover or block
the air grille on the rear cover plate of compressor at the back of
refrigerator; Keep the refrigerator away from heat source or direct
sunlight.
Loading ...
Loading ...
Loading ...